![Razz :P](./images/smilies/icon_razz.gif)
![Shocked :shock:](./images/smilies/icon_eek.gif)
![Evil or Very Mad :evil:](./images/smilies/icon_evil.gif)
![Embarassed :oops:](./images/smilies/icon_redface.gif)
So been through all I can check in the trouble shooting and don't have a clue. All seems ok/to spec.
So I want to check the error codes.
I jumpered the top GND pin (on the same half of the connector) to the TEN pin.
No HOLD light on the dash when key is turned to II. Nor when the pins are not connected.
Looked at an identical dash that I have from a scrapped mx-3 (1994 I think) and there's no HOLD bulb. There's never been one either as there's no marks on the contacts.
And no bulb in my dash? wrf???
So do I have OBDII or OBDI?
Car was registed 01 08 1995. (DD MM YYYY). So I thought it would be OBDI. (before 1996)
Can I get HOLD light readings from OBDII?
If it's defo OBDI, then what am I doing wrong?
Thanks a million for any help in advance.
(don't sell your fiesta until you can afford to have a spare mx-3
![Laughing :lol:](./images/smilies/icon_lol.gif)