I think i am going to get ripped off on ebay, any advice?
-
- Senior Member
- Posts: 2220
- Joined: October 17th, 2004, 2:01 am
- Location: SLC, Utah
I think i am going to get ripped off on ebay, any advice?
Well I recently purchased this CAI
http://cgi.ebay.com/ebaymotors/ws/eBayI ... 492&rd=1,1
I have contacted the seller asking when I should recieve it, 2 emails later, no respond.
My first email was sent on Saturday and last one was yesterday.
Still no respond
http://cgi.ebay.com/ebaymotors/ws/eBayI ... 492&rd=1,1
I have contacted the seller asking when I should recieve it, 2 emails later, no respond.
My first email was sent on Saturday and last one was yesterday.
Still no respond
2008 Mazda 3
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
- mitmaks
- Senior Member
- Posts: 8704
- Joined: September 10th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Spokane, WA
- Contact:
probably, look at how many negative feedbacks he has!!!
Magnum s/s lines, strut bars, carbon fiber bezel, indiglow gauge, Sony Xplod, inverted c/f hood, SRD lower tie bar '93 GS SE '95 Cobra SVT #2722 '68 Charger R/T 440
http://www.cardomain.com/id/mitmaks
http://www.cardomain.com/id/mitmaks
ok, i actually took the time and checked the seller profile, he seems to be very good, however some ppl did not receive their items, and some complained about the lack of communication. in any case you should realize that you are fully covered by paypal and ebay, i suggest u send a few emails, and wait a good week or two, if the item does not show up u could report the seller through paypal or ebay and get your money back eventually, you can also give the seller negative feedback.. some sellers have bad communication skills, i suggest you wait before making any assumptions... goodluck
-
- Senior Member
- Posts: 2220
- Joined: October 17th, 2004, 2:01 am
- Location: SLC, Utah
I freaking get ripped off I swear I will murder this f----n guy
He has like 99% positive feedback
.9% at bad
Its my fault for being new to Ebay
He has like 99% positive feedback
.9% at bad
Its my fault for being new to Ebay
2008 Mazda 3
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
-
- Senior Member
- Posts: 2220
- Joined: October 17th, 2004, 2:01 am
- Location: SLC, Utah
LOL
Ah man, wooo!!!!!!!!!!!!!
Ok, so I been looking at my messages on Ebay, no messages
Then I look in my GMail address and guess what...
I get my tracking number from him
Such a relief
Right now I was so pissed off before this
I thought to myself, "damn, I am going to be too pissed off to go to work tomorrow"
Ahh man such a relief
Ah man, wooo!!!!!!!!!!!!!
Ok, so I been looking at my messages on Ebay, no messages
Then I look in my GMail address and guess what...
I get my tracking number from him
Such a relief
Right now I was so pissed off before this
I thought to myself, "damn, I am going to be too pissed off to go to work tomorrow"
Ahh man such a relief
2008 Mazda 3
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
ebay ripoff
Considering it is Christmas time, shipping will most likely be delayed as well. Just don't let this go past 30 days, I believe that is the cutoff for ebay and paypal to help you recover your $$$ which is not cool in my opinion. I was ripped off on a B C Rich Warlock electric guitar a few years back when I was newer to ebay and I was basically outta luck for over $100 US.
My other advice about ebay Is make sure you know how much shipping is going to be before bidding 'cause some sellers like to hike the shipping cost to offset the low final auction bids.
I would give him a week for a response but I would be polite in the emails. You can also request the seller's personal info from ebay to get their phone number and give them a call if you want to get some peace of mind. Good luck...Barb
My other advice about ebay Is make sure you know how much shipping is going to be before bidding 'cause some sellers like to hike the shipping cost to offset the low final auction bids.
I would give him a week for a response but I would be polite in the emails. You can also request the seller's personal info from ebay to get their phone number and give them a call if you want to get some peace of mind. Good luck...Barb
ebay ripoff
Now I see that you have a tracking number, that is great, glad you aren't in the ripped off category!!!
- OROutdoors
- Supporting Member
- Posts: 339
- Joined: December 4th, 2006, 4:38 pm
- Location: Tigard, OR
Juan,
Please let us know about the quality of the intake. I find it difficult to believe in a $20.00 intake -- it is just too inexpensive. Heck, a paper Fram airfilter for an mx-3 costs $20.00. Your package costs you $39.00 and has aluminum tubes, filter (cotton wan not specified), couplers, bands and miscellaneous parts. Thats a very cheap price. Please let us know about it's quality.
I just can't see how they can offer a great product as such an inexpensive price.
Eric
Please let us know about the quality of the intake. I find it difficult to believe in a $20.00 intake -- it is just too inexpensive. Heck, a paper Fram airfilter for an mx-3 costs $20.00. Your package costs you $39.00 and has aluminum tubes, filter (cotton wan not specified), couplers, bands and miscellaneous parts. Thats a very cheap price. Please let us know about it's quality.
I just can't see how they can offer a great product as such an inexpensive price.
Eric
Oregon Outdoors
92 mx-3 GS lowered, CF hood
2013 Mazdaspeed3
92 mx-3 GS lowered, CF hood
2013 Mazdaspeed3
- mitmaks
- Senior Member
- Posts: 8704
- Joined: September 10th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Spokane, WA
- Contact:
relax dude. Ive lost much more than $30. Losing a friend is worse than losing money. I had both happen to me. Life must go on. Anyways if you're covered under paypal they'll refund your money
Magnum s/s lines, strut bars, carbon fiber bezel, indiglow gauge, Sony Xplod, inverted c/f hood, SRD lower tie bar '93 GS SE '95 Cobra SVT #2722 '68 Charger R/T 440
http://www.cardomain.com/id/mitmaks
http://www.cardomain.com/id/mitmaks
-
- Senior Member
- Posts: 2220
- Joined: October 17th, 2004, 2:01 am
- Location: SLC, Utah
Ok, thanks for the advice
I think the intake will turn out good considering other Integra intakes that were recomended to me were about just $10 more.
Well I hope
I'll let you guys know
I'll install the intake whenever I can
As for the Intake itself, I got a feeling its not going to be cotton, I'm not sure
I think the intake will turn out good considering other Integra intakes that were recomended to me were about just $10 more.
Well I hope
I'll let you guys know
I'll install the intake whenever I can
As for the Intake itself, I got a feeling its not going to be cotton, I'm not sure
2008 Mazda 3
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
1993 MX3 GS
KLZE, Fidanza flywheel, KL31 CAMs, South Bend Stage I Clutch, Pacesetter STS, SS AutoChromes, Magnaflow muffler, 2.25' Exhaust, CAI, Blaster Coil HEI, KLDE Valvetrain, 5 Speed Swap
-
- Senior Member
- Posts: 6451
- Joined: June 19th, 2004, 2:01 am
- Location: El Paso Tx U.S
- Contact:
hmm did imention i used the mx6 v6 intake ? lol it fit perfectly when I chopped and turned one elbow arounf. looks like the integra one.
-hec
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!