MSD Ignition
-
- Regular Member
- Posts: 1704
- Joined: December 31st, 2005, 5:54 pm
- Location: Burlington + Grimsby, Ontario, Canada
- Contact:
will it work, maby, would i buy it, no.
its a older version, made for gm vehicles, i would try to find a newer one, that is red in colour. and is the generic one, not made for gm.
Bochek
its a older version, made for gm vehicles, i would try to find a newer one, that is red in colour. and is the generic one, not made for gm.
Bochek
Adam Bochek's 93 1.6L SOHC http://www.bochek.ca/car.gif
-
- Regular Member
- Posts: 629
- Joined: November 21st, 2002, 2:01 am
- Location: Weyers Cave, VA
- Contact:
Use this link to see my instructions I gave in the forced induction forum to wire a MSD 6BTM Ignition...they all are wired basically the same unless you use an seperate crank trigger.
http://www.mx-3.com/phpbb2/viewtopic.ph ... fe2ebd80e9
You could have also done a search for "MSD" and came across it. This would be a nice article to add to the FAQ
http://www.mx-3.com/phpbb2/viewtopic.ph ... fe2ebd80e9
You could have also done a search for "MSD" and came across it. This would be a nice article to add to the FAQ
http://www.cardomain.com/ride/354836
B6T, APEXi Silvia IC, HKS SSQV, Magnacore KV85 Wires, NGK V-Power, Haltech E6K, Accel 300+ Digital Ign w/ coil, Accel 375+ controller, JWMmotorsports turbo manifold & exhaust, custom Garret GT-R series turbo, MAZDASPEED mounts, SRD Bushings, Pacesetter Short Shift, entire Pro LX drive train w/ custom ACT clutch (I'm the first to succeed this on B6T), Weapon-R, and lots more stuff!
B6T, APEXi Silvia IC, HKS SSQV, Magnacore KV85 Wires, NGK V-Power, Haltech E6K, Accel 300+ Digital Ign w/ coil, Accel 375+ controller, JWMmotorsports turbo manifold & exhaust, custom Garret GT-R series turbo, MAZDASPEED mounts, SRD Bushings, Pacesetter Short Shift, entire Pro LX drive train w/ custom ACT clutch (I'm the first to succeed this on B6T), Weapon-R, and lots more stuff!