Ok so after all teh hastle i just bought a used disty from a26 and it works fine. I put it on in the same place as the old one approximately and the car runs smooth and fast. Do I need to retime?
Will i damage the engine?
Thanks
ps. Does anyone have a pic of where i aim a timing light?
so i replaced the disty
- 93-Spec-Edn
- Regular Member
- Posts: 817
- Joined: April 1st, 2003, 2:01 am
- Location: alberta, canada
so i replaced the disty
92 mx-3 RS RIP | 95 mx-3 GS sold | 93 mx-3 GS SE sold | 95 mx-3 GS present
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
Are you really 75 years old and don't know how to use a timing light?
You should set the timing. It is most likely off by a degree or two which won't hurt the car, but will decrease fuel economy and add carbon build-up. Also, you should know how to time a motor so it is good practice.
Buy a timing gun at AutoZone, Napa or some place like that. You need the more expensive kind (I cannot remember what it is called). Then follow the directions on the online shop manual to set the timing.
![Laughing :lol:](./images/smilies/icon_lol.gif)
You should set the timing. It is most likely off by a degree or two which won't hurt the car, but will decrease fuel economy and add carbon build-up. Also, you should know how to time a motor so it is good practice.
Buy a timing gun at AutoZone, Napa or some place like that. You need the more expensive kind (I cannot remember what it is called). Then follow the directions on the online shop manual to set the timing.
![Image](http://www.patdiesel.atlantamx3.com/MX-3/patdieselsigMX-3.jpg)
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP