Im trying to apply this fix to my wifes mx3. heres the link http://forums.probetalk.com/showthr...#post1921336037
now my wire colors are different and her car wont start. Heres what I have
Green wire, pin (G) goes to Orange
Red wire, pin (B) goes to either Black or Blue. I cant tell, may of discolored.
White wire, Pin (C) goes to Red
Black I have grounded to the IM.
Its possible that I may of put the rotor back on in the wrong spot. but I dont think so
Another thing is that I have a remote starter that ive been using to test this. earlyer today I forgot to connect the 3 pin plug and it only tryed to start for a sec instead of the normal 10 or so.
Its doing that even though i have it pluged in.
hei mod. $20disty fix
-
- Junior Member
- Posts: 13
- Joined: May 10th, 2005, 7:56 pm
hei mod. $20disty fix
Stock 93 GS SE v6 Automatic
-
- Regular Member
- Posts: 420
- Joined: November 7th, 2000, 2:01 am
- Location: London, ON, Canada
- Contact:
I would recommend you do a search and read the FAQs of the board... many of your questions have been answered before.
here is a link that may help... http://www.mx-3.com/phpbb2/viewtopic.php?t=50154
here is a link that may help... http://www.mx-3.com/phpbb2/viewtopic.php?t=50154
-
- Junior Member
- Posts: 13
- Joined: May 10th, 2005, 7:56 pm
-
- Regular Member
- Posts: 420
- Joined: November 7th, 2000, 2:01 am
- Location: London, ON, Canada
- Contact:
I tried a search also... couple of words and in less then a minute... I found this.
http://www.mx-3.com/phpbb2/viewtopic.ph ... ht=hei+mod
cheers,
http://www.mx-3.com/phpbb2/viewtopic.ph ... ht=hei+mod
cheers,
-
- Junior Member
- Posts: 13
- Joined: May 10th, 2005, 7:56 pm
I read that yesterday too.
Bottom line. ive fixed the grounding prob w/the HEI so my starter cranks for its normal length of time now. Still no Spark! Ive tryed all three postitons for the rotor and nothing. Coils are good I tested primalry and secondary for reisitance and got 1ohm and 9.5k which was a little low but its not exactly at normal temp either. battery is 12.5v what else could it be?
Andy
Bottom line. ive fixed the grounding prob w/the HEI so my starter cranks for its normal length of time now. Still no Spark! Ive tryed all three postitons for the rotor and nothing. Coils are good I tested primalry and secondary for reisitance and got 1ohm and 9.5k which was a little low but its not exactly at normal temp either. battery is 12.5v what else could it be?
Andy
Stock 93 GS SE v6 Automatic
-
- Regular Member
- Posts: 420
- Joined: November 7th, 2000, 2:01 am
- Location: London, ON, Canada
- Contact:
this is a good description of what is going on also. Most everyone I know that has done it has been quiet successful with the instructions from here.
http://www.mx-3.com/phpbb2/viewtopic.php?t=26506
http://www.mx-3.com/phpbb2/viewtopic.php?t=26506
-
- Junior Member
- Posts: 13
- Joined: May 10th, 2005, 7:56 pm
yup already saw that one too. I think my internal coil is screwed. Im going to probably replace the disty cause i want this to run yesterday! and im not up for modding somthing to fix a prob where im not sure where it is. I know its either the coil or the ICM so im giong to replace the disty.
thanks for trying to help me through this though.
thanks for trying to help me through this though.
Stock 93 GS SE v6 Automatic
-
- Junior Member
- Posts: 13
- Joined: May 10th, 2005, 7:56 pm
thanks everyone problem resolved! I believe that it was actually the internal coil not the ICM. I verifyed that the hei mod. was wired correctly w/my uncle who works for gm. Got a rebuilt from autozone for $160 lifetime waranty put that in, reversed the hei mod and runs like before.
thanks again
Andy
thanks again
Andy
Stock 93 GS SE v6 Automatic