Bumpers and such

DizzeeRascal · Post by **DizzeeRascal** » January 11th, 2006, 12:46 pm

hey everyone, i've noticed that my bumpers front and back arent tight where they should be...like one side is down like a half inch and i was wondering if there was anyway for me to fix that?

Legato626 · Post by **Legato626** » January 11th, 2006, 9:16 pm

Just look at it. I installed my own front bumper on my car it was easy to do. But its about 8 screws that holds the stock bumper on. Make sure they are all screwed in. COuld have losened up a bit i guess. Just look at it.

PATDIESEL · Post by **PATDIESEL** » January 12th, 2006, 9:29 am

On the corners where the bumper ends in the wheel well are usually where they will start to sag first. There is a plastic clip with a screw through it that holds the bumper up to the fender. If that is missing take your car to Mazda and they can take a look and get the part for you. It is pretty cheap.

DizzeeRascal · Post by **DizzeeRascal** » January 13th, 2006, 1:23 pm

awesome

Thanks guys!