I wanted to keep the stock harness so i could put my old lights
back in if i wanted to.
The pictures i have are bad quality bc my digi is a peice. But here it is
------------------------------------------------------------------------------
-=STEP ONE=-
Take the wiring harness you got with the projectors
And take off the Black housing.
-------------------------------------------------------------------------------
-=STEP TWO=-
You will see on the metal prods that their is a line down the middle of it
cut down that line and then chop of one side(either side) 
Do that to all three
--------------------------------------------------------------------------------
-=STEP THREE=-
Then guess what.....
Its plug and play time...
Thats right.
Plug it into your stock housing.
IT JUST SLIDES IN.
****************************************************
*match the colors from behind the housing.
*ex"black wire=black
*red =red and the blue one hooks up to the last one
*(red with grey stripe).
****************************************************
----------------------------------------------------------------------------------
Plug the original project harness into the projectors and YOUR DONE
* I recommend tiddying up the new harnes you made with some eletrical tap.Its all up to you.
____________________________________________
You can hook up your halos a million different ways
I just attached them to the projectors wiring harness.
____________________________________________
Hope this helps everyone out. And if your thinking about doing this mod
YOU MUST...It makes your car 1000000 times more amazing to look at.
</pre>