question

skillz1two · Post by **skillz1two** » December 6th, 2005, 10:22 pm

does anyone if this muffler would fit into the mx3. the size is It's about 18" long, 6" wide, and the inlet/outlets seem to be 2.25".

the link for the picture is this

http://img.photobucket.com/albums/v93/s ... G_1927.jpg
http://img.photobucket.com/albums/v93/s ... G_1928.jpg

sk8erdude28 · Post by **sk8erdude28** » December 6th, 2005, 10:27 pm

fieromx3 · Post by **fieromx3** » December 6th, 2005, 10:32 pm

yep just go to an exhaust shop and tell them u want this muffler on this car and they will maybe trim ur piping and put a coupler on the pipin to fit ur muffler and all that stuff they might charge around 90 bux or u can do what i did spend 25 for the materials needed and trim the pipe urself and put a coupler on slide the muffler in the coupler and bolt it to tighten it on and find a way to hang it.

sk8erdude28 · Post by **sk8erdude28** » December 6th, 2005, 10:36 pm

90 bucks? I think that's a bit much. *i think* I guess it depends on the area though.

But ya you're right. it should be easy. You can mount it easily with just a muffler strap too

fieromx3 · Post by **fieromx3** » December 6th, 2005, 10:49 pm

well i got diff quotes and it was like 75 and up. its alot just cuz of the labour and materials like welding coupler bolts straps and all but mainly labor.

sk8erdude28 · Post by **sk8erdude28** » December 6th, 2005, 10:57 pm

yeah for sure. I geuss that makes sense

jschrauwen · Post by **jschrauwen** » December 11th, 2005, 2:18 am

What was wrong with getting a muffler designed for the car?
Oem piping isn't 2.25"

fieromx3 · Post by **fieromx3** » December 11th, 2005, 10:27 am

there is a muffler designed for our car? but anyway it only takes a 5 dollar piece to adapt r pipin size to fit that 2.25'' muffler inlet