Gasket Kits?

jbruynson · Post by **jbruynson** » October 27th, 2005, 1:18 am

I asked a while back in another thread about the required gaskets and such for a ZE swap. Just from reading im pretty sure the gaskets are the same on all the k series engines. I came across this gasket kit?

I've never really heard anyone talk about kits before though, which is why im asking.

The site is http://www.importperformanceparts.net/ , click Mazda, then gaskets, then TOGA HP Gasket Sets, part # CGSMA15HP.

Opinions on this? will this even work? Too expensive? Any other major gaskets i'd need?

Thanks

babyblueMX3 · Post by **babyblueMX3** » October 27th, 2005, 7:09 am

why not get just a oem HG from mazda ? THey are strong enough let me tell you that !

jschrauwen · Post by **jschrauwen** » October 27th, 2005, 11:23 am

I imagine that oem Probe gaskets should do nicely also and probably a bit cheaper too.

jbruynson · Post by **jbruynson** » November 1st, 2005, 12:18 am

Just wanna confirm before I go ahead and buy this. It seems fairly cheap for a complete gasket set. I'd rather pay a bit more than have to phone around mazda/ford/whoever.

Located at http://www.autopartsgiant.com

Part# 09-01165
[Full Gasket Set] CR 9.2:1 75mm K8 24V Eng; DOHC; GS

Plz correct me if im wrong, but this gasket set will be fine for a ZE? This would also be all the gaskets i'd need correct? probably more than i'd really need?

Thanks a lot

ocshaman · Post by **ocshaman** » November 1st, 2005, 12:48 am

I have a code that might help you

10145

It is supposed to be good until at least 10/21. Try it out and see if it works. If it does, you can thank me by telling me, so I can use it for VC gaskets.