This is the jackshaft and/or intermediate shaft.
and this is the jackshaft connected to the passenger axle. and the other axle is the driver's side.
these are not actually MX3 axles but they look almost exactly the same...you should call mazda and ask for an intermediate shaft, bearing, bracket, and the 3 bolts to hold it on.
EMERGENCY / TRANNY RELATED
- ryanlindenberg
- Regular Member
- Posts: 874
- Joined: February 24th, 2003, 2:01 am
- Location: Minnesota
CARDOMAIN WITH UPDATED PICS
"There are 2 kinds of pedestrians, the quick and the dead."
"There are 2 kinds of pedestrians, the quick and the dead."
- ryanlindenberg
- Regular Member
- Posts: 874
- Joined: February 24th, 2003, 2:01 am
- Location: Minnesota
oh yea and crappy auto parts stores don't stock the part..i looked around when i bought new axles for my bpt...most of the people looked at me dumb and didn't know what i was talking about. little did they know that they were the retarded ones...the people that did know what i was talking about told me they didn't sell them.
CARDOMAIN WITH UPDATED PICS
"There are 2 kinds of pedestrians, the quick and the dead."
"There are 2 kinds of pedestrians, the quick and the dead."
-
- Regular Member
- Posts: 339
- Joined: January 9th, 2004, 2:01 am
- Location: Philly
- Contact:
so i know that the axle for the automatic is a half inch longer then that of the manual. But is it the axle thats shorter or the jackshaft thats shorter?
In other words, is it the jackshaft thats different from auto to manual or is it the outer axle assembly?
In other words, is it the jackshaft thats different from auto to manual or is it the outer axle assembly?
www.illegalCustoms.com
Tri-State Area Car Club
Tri-State Area Car Club
- atlantamx3
- Supporting Member
- Posts: 2888
- Joined: June 2nd, 2001, 2:01 am
- Location: Kennesaw, Ga, USA
- Contact:
-
- Regular Member
- Posts: 339
- Joined: January 9th, 2004, 2:01 am
- Location: Philly
- Contact:
i care because i have the outer shaft already installed and i was going to use it. but if its the outershaft thats different from auto to manual and not the jack shaft, then i need both parts! please help i need this by the weekend.
the parts store said they found a jack shaft that they are not 100% sure its the right one but its about 22.5 inches long. hes getting it tomorrow at 3 o clock. sounds a little long dont ya think?
the parts store said they found a jack shaft that they are not 100% sure its the right one but its about 22.5 inches long. hes getting it tomorrow at 3 o clock. sounds a little long dont ya think?
www.illegalCustoms.com
Tri-State Area Car Club
Tri-State Area Car Club
- atlantamx3
- Supporting Member
- Posts: 2888
- Joined: June 2nd, 2001, 2:01 am
- Location: Kennesaw, Ga, USA
- Contact:
-
- Regular Member
- Posts: 339
- Joined: January 9th, 2004, 2:01 am
- Location: Philly
- Contact:
I said it fit with force. but the holes for the bracket did not line up with the holes on the block. we had to push it in pretty hard. but i still cannot find the part!!!!!!!!!! does anyone have one?!!!!!!!!!!!!!!!!!!!!!!!!!!!!
www.illegalCustoms.com
Tri-State Area Car Club
Tri-State Area Car Club