Is this a dealer part?
- azazel95
- Regular Member
- Posts: 264
- Joined: May 23rd, 2005, 1:56 am
- Location: Cincinnati, OH
- Contact:
Is this a dealer part?
I need a new (not sure of actual name) cushion for the engine mount that is located near the pulley system on the strut tower. I looked on Autozone.com but couldn't find anything. Its not providing the cushion well causing the engine to knock around. Any help appreciated.
- Tunes67
- Supporting Member
- Posts: 4708
- Joined: January 27th, 2005, 6:36 pm
- Location: Everett, WA
- Contact:
No.. you can just unbolt it and replace it.. worst case you might need to push or pull on the engine (From front to back) a little to get the bolt holes to line up.. its more of a idler type of mount.. doesnt actually support any weight.. just keeps the engine from moving excessively.
Tunes67
Tunes67
"So long.. and thanks for all the fish!" "Momma says VW Bugs are the devil" "This one time at band camp.. I stuck a flute in my Throttle Body"
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
- neutral
- Supporting Member
- Posts: 1770
- Joined: December 27th, 2004, 10:19 am
- Location: U.S. Mid Atlantic
Agree w/Tunes. Should only need to add temp support for the engine/tranny if replacing the lower mounts which do support the motor.azazel95 wrote:Yes I have a 95 RS and I believe it is the belt side motor mount. Thanks for the link. I'm assuming I will need to support the engine in order to replace the mount, correct?
-Jim
-
- Regular Member
- Posts: 111
- Joined: July 31st, 2004, 2:01 am
- Location: Miami, FL