ZX2 question
- ooELMOoo
- Regular Member
- Posts: 372
- Joined: April 28th, 2005, 2:32 am
- Location: Vancouver, BC , Canada
ZX2 question
I here so much about the ZX2...do they fit the mx-3 without modification.......what is the best way to lower the mx-3 without dropiing like 500$.......What type of setups do you guys have??
----------------
| CUSTOM X3|
----------------
| CUSTOM X3|
----------------
- GreenMachine
- Regular Member
- Posts: 91
- Joined: December 6th, 2003, 2:01 am
- Location: Oakley
- neverenuff
- Supporting Member
- Posts: 608
- Joined: January 24th, 2002, 2:01 am
- Location: BLACKWOOD N.J.
Well I can tell yo this I just got the whole ZX2 set up. But I got every thing. struts were like 80 something a piece. This is US funds. but by the time I was done with new boots,perch, barings ex. it was a total of $800.00 I literaly got a whole new ZX2 setup. I havent installed them yet but for what I payed I pray it's a sweet setup. Ohh by the way after spending that much on just struts and new parts for them I went with the Ground Control coilovers (I know I know )CRAP so I heard. But to be honest I not worried about the clunking noise because of some bushings I am going to put in place.
Since when are GC's crap?REDRM26 wrote:Well I can tell yo this I just got the whole ZX2 set up. But I got every thing. struts were like 80 something a piece. This is US funds. but by the time I was done with new boots,perch, barings ex. it was a total of $800.00 I literaly got a whole new ZX2 setup. I havent installed them yet but for what I payed I pray it's a sweet setup. Ohh by the way after spending that much on just struts and new parts for them I went with the Ground Control coilovers (I know I know )CRAP so I heard. But to be honest I not worried about the clunking noise because of some bushings I am going to put in place.
92 GS
'Stock'...
'Stock'...
-
- Senior Member
- Posts: 3391
- Joined: November 30th, 2001, 2:01 am
- Location: Stuttgart, Deutschland
- Contact:
don't forget the shaft diameter is different...you need to bore out your front perch hats and get the zx2 thrust bearing too
other than that, they are bolt on
other than that, they are bolt on
Noble Green Metallic 93' GS Hybrid, 91' 1.8 323
DONATE TO MX-3.COM
DONATE TO MX-3.COM
- neverenuff
- Supporting Member
- Posts: 608
- Joined: January 24th, 2002, 2:01 am
- Location: BLACKWOOD N.J.
Well I spent the money so #1 everything will be just bolt on with out having to bore out anything and #2 with my car having 145k miles on it everything is pretty rusty and dirty and I want it all to be new so I wont have to worry about anything in the future. And I need to correct myself I ment Drop Zone not Ground Control sorry.
- neverenuff
- Supporting Member
- Posts: 608
- Joined: January 24th, 2002, 2:01 am
- Location: BLACKWOOD N.J.