Cylinder Head Question

phredren · Post by **phredren** » March 22nd, 2005, 6:56 pm

I searched and couldn't find my answer... is the DOHC 1.6L head compatible with the B6T bottom end?

Tunes67 · Post by **Tunes67** » March 22nd, 2005, 7:00 pm

I am not positive on this.. since I havent seen a B6T bottom end.. however.. the DOHC 1.6L is off of a B6ZE engine (at least mine is) I would think with both engines being B6's.. that the differences would be internals rather than with block or head casting.. so I would "Think" that it would fit. But like I said.. I dont know for certain.

Tunes67

phredren · Post by **phredren** » March 22nd, 2005, 11:31 pm

I pulled the B6T head off my B6T today and found that the B6D head is interchangable. There are two extra small oil drain holes on the B6D head that aren't on the B6T head, but thats not a big deal at all because there are still 4 big drain holes.

phredren · Post by **phredren** » March 23rd, 2005, 10:23 pm

^ Those two extra drain holes I mentioned need to be plugged up.