what kind of distributor fit in a KL-ZE?

wagZE · Post by **wagZE** » March 17th, 2005, 10:04 pm

i need to know to know what ones to put in, what one would be the cheapest mine is effed.
PS wtb disty

mxmaz · Post by **mxmaz** » March 17th, 2005, 10:05 pm

use the same as the mx3 uses

wagZE · Post by **wagZE** » March 17th, 2005, 10:37 pm

would a probe gt one fit? the 2.5l one?
i can get one of those cheap.
but a mx3 1.8l distributor will fit in a KLZE 2.5l engine?

kiwi_MX3 · Post by **kiwi_MX3** » March 18th, 2005, 3:55 am

Yes a mx3 dizzy will fit the KLZE block.......

bmwm3guy · Post by **bmwm3guy** » March 18th, 2005, 9:22 am

all k-series distys are interchangeable..

Im sure this has been covered before dozens of times. The ZE disty has a 3 wire harness, so you need to splice the new connector onto your wiring harness and run the third wire to a ignition switch. CHeck the FAQ section for more details.