Alignment
-
Bri94GS
- Regular Member
- Posts: 1079
- Joined: February 13th, 2001, 2:01 am
- Location: Hartford, CT
- Contact:
Alignment
My way was pulling to the left, so i brought it to get an alignment today. When they finished, I have a note on my slip that says "CASTER ADJUSTMENT IS MAXED, POSSIBLE BENT LOWER CONTROL ARM, THE CAR MAY DRIFT TO THE RIGHT", but yet it still drifts to the left...not really sure what the lower controller arm is...any suggestions? thanks
-
Sonicxtacy02
- Senior Member
- Posts: 2053
- Joined: January 1st, 2001, 2:01 am
- Location: Woodbridge, VA, USA
- Contact:
Re: Alignment
My first response would be did they actually do the alignment? If they did it was a waste of your money. the didnt correct the alignment and they didnt fix the needed repairs so once you replace the control arm you'll just have to get the car aligned again. 
Shaun Newman
SOLD 1994 Blaze Red GS/ SOLD 1994 Chaste White GS-R
SOLD 1994 Blaze Red GS/ SOLD 1994 Chaste White GS-R
-
jaydog5678
- Regular Member
- Posts: 1043
- Joined: March 27th, 2002, 2:01 am
- Location: Marietta, GA,
- Contact:
Re: Alignment
You may have a radial pull. A tire could possibly be the problem. A temporary fix, if the alignment was done correctly, rotate the tires. If it still pulls, than you need to start looking at new suspension parts. Did they give you an alignment readout?
-
Bri94GS
- Regular Member
- Posts: 1079
- Joined: February 13th, 2001, 2:01 am
- Location: Hartford, CT
- Contact:
Re: Alignment
yea, i have a read out, and they said they'd align it again once i got the part in....
-
David Coleman
- Senior Member
- Posts: 2516
- Joined: November 7th, 2000, 2:01 am
- Location: Gainesville, FL USA
- Contact:
Re: Alignment
Moved to the forum that deals with suspension and not engine performance.
David Coleman
I used to know alot about MX-3's, but not so much anymore. Oh well.
I used to know alot about MX-3's, but not so much anymore. Oh well.