Walbro 190lph.....which model for my mx3???

94mx3rsr · Post by **94mx3rsr** » April 16th, 2003, 9:44 pm

hey....i am swapping my bpt in may in my 94 mx3 RS and i have heard good about the walbro 190lph and i'd like to know which exact model of 190lph do I need so i can order it!<p>Thanks<p>mx3jmcbpt

boostedmx · Post by **boostedmx** » April 17th, 2003, 8:44 am

you can get the inline pump or the one made for the miata or 3rd gen rx7. the two intank pump will need some custom brackets to mount. the inline one is way easier to install and can be wired a number of different ways.

mdavis · Post by **mdavis** » June 18th, 2004, 4:04 pm

Hm. If I go with an inline, what inlet/outlet fittings do I want? Thanks.

mrspanky79 · Post by **mrspanky79** » June 19th, 2004, 4:34 pm

the 190hp for the mx6 intake bolt right in

rebel2k4 · Post by **rebel2k4** » June 20th, 2004, 2:46 pm

I am using an 190lph intank walbro unit for a 88-92 mx6. The stock wiring clip plugged right in. only thing was it seemed a little too tall and the rubber grommet on the bottom of the pump wouldnt fit so I just left it off.

BTW this is in my 94 GS.

Josh · Post by **Josh** » June 21st, 2004, 2:42 am

i dont know, i used a 3rd gen RX7 pump and it went in no problem at all. the main difference was the filter was smaller than the stock one on the MX. there were no brackets to customize

MX-3.com

Walbro 190lph.....which model for my mx3???

Walbro 190lph.....which model for my mx3???

Re: Walbro 190lph.....which model for my mx3???

Re: Walbro 190lph.....which model for my mx3???

Re: Walbro 190lph.....which model for my mx3???

Re: Walbro 190lph.....which model for my mx3???

Re: Walbro 190lph.....which model for my mx3???