EVO V Bumper Pics COMPLETED PICS ADDED

A forum for Appearance Discussions. (Exterior, Body Kits, & Interior)
streetconcepts
Regular Member
Posts: 158
Joined: October 6th, 2003, 2:01 am
Location: Altoona PA
Contact:

EVO V Bumper Pics COMPLETED PICS ADDED

Post by streetconcepts »

Should be finished tomorrow.

EVO V Development

I'll be starting the Blitz immediately after this is finished.

<small>[ January 12, 2004, 01:43 PM: Message edited by: streetconcepts ]</small>
Craig Flango
Body Kit Development Specialists
onlinesales@krazykustomz.com
Drift - EVO 5 - Blitz - BC2 - KMAX
streetconcepts
Regular Member
Posts: 158
Joined: October 6th, 2003, 2:01 am
Location: Altoona PA
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by streetconcepts »

Also this bumper has 5" of clearance with the Eibach lowering kit installed.
Craig Flango
Body Kit Development Specialists
onlinesales@krazykustomz.com
Drift - EVO 5 - Blitz - BC2 - KMAX
Tyler17rose
Regular Member
Posts: 846
Joined: October 19th, 2002, 2:01 am
Location: Ottawa, Ontario, Canada
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by Tyler17rose »

:2thumbsup: Thats gona be sweet. Specially since it wont be a snow plow.
Mods:
- ZE, Mike seli 214 intake cams, Ported n polished heads, Interprep valve springs, DE retainers, rebuilt bottom end, toga main and rod bearings, toga hv oil pump, CZT 67mm tb, mbx udp, ported intake mani, SS headers, 2.5inch full exhaust, racingbeat muffler, highflow cat, megasquirt v2.

new toy, 86 TII rx7, JDM S5 motor/turbo, + alot of other goodies
User avatar
BoOdOg
Supporting Member
Posts: 388
Joined: April 8th, 2003, 2:01 am
Location: Nova Scotia
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by BoOdOg »

looking very good
User avatar
EZ_4_FUN
Supporting Member
Posts: 1026
Joined: April 2nd, 2001, 2:01 am
Location: Toronto
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by EZ_4_FUN »

Looks almost like the MP5 to me.. :shrug:
OSKY
95 MX-3 GS ZE Turbo: MSnS-extra, AEM WB, Blitz boost controller, MSD 6A w/ Blaster2 Coil, ZE disty, Redtops @ 550, Walbro 255, Garrett T3/T04E 60 Trim w/ .63 A/R, 38mm Deltagate Mark II @4psi, FMIC, Apexi BOV, CM Dual friction, 4-6.25 Kickers, 2ch Alpine V12. That's Alll.

http://www.pakfeifertuning.com
User avatar
babyblueMX3
Supporting Member
Posts: 3755
Joined: February 23rd, 2003, 2:01 am
Location: Gatineau,Quebec,Canada
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by babyblueMX3 »

kind of reallll close..but still different
RIP 400whp ZE-T MX-3
Current car : Golf 01 GTI 1.8T (15 psi)
kuruption1983
Senior Member
Posts: 2030
Joined: February 3rd, 2002, 2:01 am
Location: Toronto, Ontario, Canada
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by kuruption1983 »

[quote]Originally posted by EZ_4_FUN:
Looks almost like the MP5 to me.. :roll:
Image
Marlon
Senior Member
Posts: 2034
Joined: July 21st, 2001, 2:01 am
Location: Ontario Canada

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by Marlon »

Originally posted by kuruption1983:
Originally posted by EZ_4_FUN:
Looks almost like the MP5 to me.. :roll:
i kinda think it dose to
if i was to get a new front kit it would be this front
good work looks good
1993 MX-3 GS V6 - Stock
2004 MazdaSpeed MX-5
2004 RX-8 - Project
User avatar
Trevor
Regular Member
Posts: 894
Joined: November 11th, 2002, 2:01 am
Location: Thorold
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by Trevor »

It looks a little wide to me. I think it would look killer if it went stright down from the fender.
P.S. I agree with EZ_4_FUN
User avatar
mitmaks
Senior Member
Posts: 8704
Joined: September 10th, 2001, 2:01 am
antispam: ~SPAM*SUX~
Location: Spokane, WA
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by mitmaks »

definitely looks nice.
Magnum s/s lines, strut bars, carbon fiber bezel, indiglow gauge, Sony Xplod, inverted c/f hood, SRD lower tie bar '93 GS SE '95 Cobra SVT #2722 '68 Charger R/T 440
http://www.cardomain.com/id/mitmaks
Image
User avatar
Sam Baker
Regular Member
Posts: 1461
Joined: May 23rd, 2003, 2:01 am
Location: Wellington, New Zealand

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by Sam Baker »

Originally posted by Eggo:
It looks a little wide to me. I think it would look killer if it went stright down from the fender.
P.S. I agree with EZ_4_FUN
i agree tho.. its kinda wide :shrug: ...but i shouldnt say anything coz i'm waiting on blitz. LOL but i do think it looks tight! nice work guyz.. i'm just thinkin these 2 kits Drift and Evo and reaaally wide :freak:
~ sam
92 Autozam AZ3
User avatar
millionflame
Regular Member
Posts: 960
Joined: March 4th, 2002, 2:01 am
Location: Van Island, BC
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by millionflame »

Craig, are you going to be integrating the stock turn signals into this bumper, or just use the sidemarkers like on the Drift style bumper?

Good work so far.
~ Millionflame (94 GS 120K)
quicksliver
Regular Member
Posts: 779
Joined: July 3rd, 2003, 2:01 am
Location: Barrie, Ontario, Canada
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by quicksliver »

Originally posted by Eggo:
It looks a little wide to me. I think it would look killer if it went stright down from the fender.
P.S. I agree with EZ_4_FUN
You're dumb. It's an EVO kit, it's supposed to be wide :roll: .
User avatar
atlantamx3
Supporting Member
Posts: 2888
Joined: June 2nd, 2001, 2:01 am
Location: Kennesaw, Ga, USA
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by atlantamx3 »

Looks Sick!

My only concern would be how far the front sticks out.. it looks like a shelf or a bench.

I am going to have to see this painted or at another angle or something...

<small>[ January 08, 2004, 12:10 PM: Message edited by: atlantamx3 ]</small>
~Perry
Please visit
http://www.mx3-atlanta.com
Image
streetconcepts
Regular Member
Posts: 158
Joined: October 6th, 2003, 2:01 am
Location: Altoona PA
Contact:

Re: EVO V Bumper Pics COMPLETED PICS ADDED

Post by streetconcepts »

new pics uploaded.

EVO V

Tomorrow I'll finish the detail work and mount the headlights and take it outside for pictures.

Also uploaded pics of the frenched door handles.

Frenched Door Handles
Craig Flango
Body Kit Development Specialists
onlinesales@krazykustomz.com
Drift - EVO 5 - Blitz - BC2 - KMAX
Post Reply

Return to “Appearance”