I just got a K & N filter ... I took out the big ulgy box but I still have the cheap plastic tubing ... any idea's on what I can replace this with and can you have pictures to show me ... also can I take off the mass air sensor cause its from my old 1.8L and it gives me errors after driving on the hiway for a bit . sorry I forgot to add ... I now have a 2.5 V6
<small>[ May 31, 2004, 10:27 PM: Message edited by: Friendlyhacker ]</small>
need cold air intake idea's
-
- Junior Member
- Posts: 12
- Joined: May 29th, 2004, 2:01 am
- Location: Toronto
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
Re: need cold air intake idea's
1.6L? Do you have a V-6 or 4 cyl.? Anyway you can make one from stainless or steel, both are sold by JC Whitney in a mandrell bent "U" pipe, under the exhaust section, that you can cut and then have welded at a local muffler shop. As for the MAF or VAF you really should keep it unless you have an engine management system.
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP