Minenia manifold

mdavis · Post by **mdavis** » January 28th, 2004, 10:29 pm

Hey guys. I have a question about ZEs/smog/intake manifolds. I understand the California EGR delima, and I would like to just drill the needed hole in my curved-neck ZE intake manifold... Has anybody actally done this? Any pointers, anything to watch out for (seems easy, but I would hate to mess it up!) Also I am considering a Milenia manifold - I assume all years are the same..? (2.5L) Thanks!

Steeb · Post by **Steeb** » January 28th, 2004, 10:47 pm

im in cali, and i pass smog with out egr equipment. the ze should run cleaner than your k8, ze being in good condition. anyway, jdm cars are not tapped for egr so even if u tap your manifold there is no hole on the head where it is on cars equipped with egr. just remove all traces of it and they probably will not notice especially if u have the jdm ecu that has no egr code programed into it, so ull get no check light either

babyblueMX3 · Post by **babyblueMX3** » January 28th, 2004, 11:32 pm

just go get the 2.5 millenia manifold..there not all the same..get the 96' millenia manifold..there are some of 95 that works but not all of em

mdavis · Post by **mdavis** » January 30th, 2004, 10:26 pm

Thanks

mdavis · Post by **mdavis** » February 10th, 2004, 4:03 am

Hey, where is a good place to buy a Millennia Manifold? Thanks!

killerpickle · Post by **killerpickle** » February 10th, 2004, 4:22 am

www.car-part.com

MX-3.com

Minenia manifold

Minenia manifold

Re: Minenia manifold

Re: Minenia manifold

Re: Minenia manifold

Re: Minenia manifold

Re: Minenia manifold