I got a 92 MX-3 white 2.5 KL (aka whitefish old ride)But I have no heat.I have changed the rad coolant and thermostat(180).Also changed the upper and lower rad hoses. But still no heat.It blows all cold air when I point the air to my feet and warm air from the vents but never hot even after driving for 3hours.
Does anyone know what I should do next?
clubnightspice#hotmail.com
No heat problem with 2.5 KL HELP!
- monstar-mx-3
- Regular Member
- Posts: 1112
- Joined: February 28th, 2002, 2:01 am
- Location: vancouver
Re: No heat problem with 2.5 KL HELP!
might be time to change your whole heating unit under the dash.
- wyldside
- Supporting Member
- Posts: 1364
- Joined: February 2nd, 2002, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Cheadle, Alberta, Canada
- Contact:
Re: No heat problem with 2.5 KL HELP!
Double check the fuses first. You never know...
James Gosteli
X-Prez of MX-West
1992 Seal-Gray MX-3 GSR-ZE (KLZE 2.5L V6)
1992 White MX-3 GSR-ZE (KLZE 2.5L V6) Worklog (Parting out)
1993 Blaze Red MX-3 GS - RIP
X-Prez of MX-West
1992 Seal-Gray MX-3 GSR-ZE (KLZE 2.5L V6)
1992 White MX-3 GSR-ZE (KLZE 2.5L V6) Worklog (Parting out)
1993 Blaze Red MX-3 GS - RIP
- monstar-mx-3
- Regular Member
- Posts: 1112
- Joined: February 28th, 2002, 2:01 am
- Location: vancouver
Re: No heat problem with 2.5 KL HELP!
Make sure you got the right mix of coolent and water. YOu need a tester for that. Its pretty cheap.
Re: No heat problem with 2.5 KL HELP!
Another thing to check - the distribution flaps in the heater box which control the airflow.
Re-shaped and re-sized gearshift lever. Best driveability mod you can do!
Extra thick soundproofing in the boot (trunk) to quieten my stainless steel exhaust system
Extra thick soundproofing in the boot (trunk) to quieten my stainless steel exhaust system
- Nd4SpdSe
- Senior Member
- Posts: 11212
- Joined: May 25th, 2002, 2:01 am
- Location: Québec City, Quebec, Canada
- Contact:
Re: No heat problem with 2.5 KL HELP!
make sure the ducting is still on the blower, its under the dash of the passenger seat, mine was partially knocked off and was blowing cold air, that and the thermostat went
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
- Zoso124
- Forum Moderator
- Posts: 1100
- Joined: November 7th, 2000, 2:01 am
- antispam: No
- Location: Sterling, VA
Re: No heat problem with 2.5 KL HELP!
Make sure there is enough coolant in the system. You know you fill it up between the heads and not the radiator cap. You gotta get all the air out of the system.
Mike Evans
Gone:
92 GS Tropical Emerald MTX 2.5L
93 GS Raspberry Metallic SE MTX 1.8L
Gone:
92 GS Tropical Emerald MTX 2.5L
93 GS Raspberry Metallic SE MTX 1.8L