will a straight neck TB fit the US millenia IM?

[Sean Mandell]

I just got a great deal on a us-spec millenia intake mani. The only thing is it did not come with the Throttle body. Will the straight neck TB off the klze fit my new intake?

[timpronk]

wheres the deal from, becouse we like deals. I cant see why it wouldnt fit, I have used a klze throttle body from a straight neck on a 1.8 manifold and na 2.5 manifold and that works fine.

[curtklze]

it will bold on no problem, but because it has a smaller inner diamiter you will have less air flow and you will loose some H.P.<p>you could try the local pick a part wreckers for a TB from a 2.5 probe,626,Mx-6.

[sampsonmx3]

It didnt fit right on mine because of 1 the coolant line or 2 the TPS sensor is located on the opposite side. I cant remeber which reason though.

[Zoso124]

No it won't fit, look in the V6 FAQ, I did a little write up a while back, though I never uploaded any pictures.

[Sean Mandell]

Ok that was some good info. are the 2.5 and 2.3 millenia TB's the same part#? can I bore my k8 TB to 65mm? how much will that cost?

[SimonPK]

you might find the studs on the end of the inlet manifold the wrong length so at worst you will just have to swap them over as well & also make up a bracket to hold the throttle cable. Otherwise ok.