My RPM goes up and down, does anybody know why?
I just replace my water pump and timing belt i don't think that will effect it.
need help
-
- Junior Member
- Posts: 15
- Joined: January 28th, 2003, 2:01 am
- Location: California
- Contact:
need help
92 Mazda Mx-3 V6 GS
Re: need help
My RPM goes up and down too but not hole time...it stays 0,8 (about) or 1,3 (about)...
Why?
Why?
Angel
-
- Regular Member
- Posts: 32
- Joined: December 21st, 2001, 2:01 am
- Location: Canada
- Contact:
Re: need help
An idle that oscillates like this is a sign of air leaking past a closed throttle plate or a mis-adjusted throttle position sensor. <p>Have you cleaned the throttle body with carb cleaner recently? Have you played with the idle air screw? Is the throttle closing completely? Has the TPS been replaced or adjusted lately?
Mike<BR>94 PGT <A HREF="http://home.golden.net/~trinity" TARGET=_blank>Codes, Maint, MAF, PCMs etc...</A><BR>Supermoderator, mx6.com
-
- Junior Member
- Posts: 15
- Joined: January 28th, 2003, 2:01 am
- Location: California
- Contact:
Re: need help
I have touched it once the throttle position sensor, but it wasn't that bad after i try to adjust it, now is getting worse when is in Neutral. Do you know how to Adjust it? please let me know.<p>Thanx
92 Mazda Mx-3 V6 GS
-
- Junior Member
- Posts: 15
- Joined: January 28th, 2003, 2:01 am
- Location: California
- Contact:
Re: need help
I have touched it once the throttle position sensor, but it wasn't that bad after i try to adjust it, now is getting worse when is in Neutral. Do you know how to Adjust it? please let me know.<p>Thanx
92 Mazda Mx-3 V6 GS
Re: need help
How about this, mine usually idles at 800rpm. Though, when I put it in gear and have the clutch disengaged it will slowly rise to 1500rpm then drop, quickly, back down to 800. This only happens with the clucth disengaged and in gear. Not just when the clutch is pushed in.
Re: need help
TTT
-
- Junior Member
- Posts: 15
- Joined: January 28th, 2003, 2:01 am
- Location: California
- Contact:
Re: need help
Hey guys,<p>
I found out why my RPM goes up and down, it is a little screw on top of the throttle body that need be adjusted,
I found out why my RPM goes up and down, it is a little screw on top of the throttle body that need be adjusted,
92 Mazda Mx-3 V6 GS