MX-3.com

I saw this on ebay<p>
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33701&item=2416953673<p>they are not mine.

your idle jumps most likely due to the throttle position sensor being set incorrectly (or left at the setting of the k8)<p>You will need to adjust the tps and idle settings. Lots of people say no dont do this, as does the manual. But they are not taking into consideration that you have swapped the e...

ok

do you have an external coil and ignition system? <p>If not you will need to use the distributor from the 1.8 or from a north american 2.5. The reason being is that they have an ignitor and coil built into the distibutor.<p>So if your trying to start it with the ze distributor without the external c...

Any one interesting in having a gathering in brantford ontario. There is a pretty good spot to have one just off the 403, it has a gocart track some food and a parking lot.???

do these carbon fiber hoods have to be mounted with hood pins, or can they be mounted with existing hood latch hardware.<p>Are there any scoops on this set of hoods and what is the cost of the hood.<p>Thanks.

the firing order is the same, its just the wires go to different spots on the cap. <p>So just make sure you have the correct cylinder wire going to the correct number on the cap (eg. cap #1 going to cylinder #1 ect...) just match the numbers.<p>The ze distributor will require an external coil so jus...

it just so happens that Jeff has gone through all the trouble of posting the mazda manual for the mx3 online.<p>Just go here: http://www.mx-3.com/95-manual/index.cfm <p>page F2-018 is a trouble shooting guide, and it has some listings that may help (19.) lack of power (20.) poor acceleration<p>that ...

if the idle jumps from 4-500 to about 1600 rpms then back down again, they may need to adjust the throttle position sensor. Mine started to jump around at about 240,000 km, after adjustment it was fine. <p>But if the car just dies while your driving it and you have to wait about a minute before it w...

I would like to buy a distributor and cap that comes with the klze (external coil capable)<p>Preferably around the brantford ontario area, becouse I dont want to have it shipped ....<p>and of course they must be in good shape.<p>please let me know at timpronk@rogers.com & tim@gldstudio.com<p>Tha...

you can send me some info/pics on this little crx. Any rust?, 4 wheel discs? Air conditioning?<p>send to timpronk@rogers.com

pics of hood and bumper please<p>mailto:tim@gldstudio.com<p>timpronk@rogers.com

well I had the same prob when I did my swap, and my manual never showed a bolt under the rubber either. So I just left it on the tranny. I had the car jacked up high and just lifted the engine out with the tranny and the shifter linkage all at once! This worked out fine for me, no probs.

mine is a black gs, small white letters on the fender that say klze, lowered with tsw's.<p>any thoughts on a rim trade without rubbers? I have had my rims for a few yrs and would like to try something diff but my tires I bought last summer.

just the rims or rubber as well?

I dont think I ever see you driving around town. Maybe someone should start a brantford area meet. Since there are a bunch of people on this board from around that area.<p>I have 17" tsw evos, maybe a swap?