MX-3.com

as for exhaust do like me just go to a muffler shop and get a lengh of 2in pipe and make your own and if they do it for cheap take off your rear portion of the exhaust and see if they match the bends for the over axle section


Reaper

alittle off tpoic but back to a previous post mazda did make a four cylinder deissle engine in one of the b2200 model it the same engine in one of the smaller mitsubishi in the uk i already looked in to the bd side of the engine options problem is you would save more cash by convertion the mx to rea...

one easy fix is got and get a aftermarket steering wheel, they are about 10.5" in diameater a huge differenes than stock after that you can get different spacers to bring the wheel farther off the steering colum, and all this envols is removing your stock wheel not trying to swap the entire ste...

you just really have to get one or tweo pc fans and if a way to attach them. i used zipties, after that just wire them to the ground cable from the amp and the power you'll get from the remote turn on wire that why it's only running when the amp is on.

hope that helps

reaper
greg

ya after i switched to a red top alot of problems have died down just don't store your battery on cement floors apparlenty it will drain the battery i don't know how it just a warning i was told [/list]

i find that funny according to the shop manual i shouldn't have two fans on my car unless my four banger really needs them

you get what you pay for when i comes to alarms thing to look for range ajustable shock sensor upgradeabltiy type of remote eg two way paging viper alarms ar owned by directed electronics which also owns clifford alarms both come with a lifetime warrenty on the brain of the alarm which is a good thi...

just get a kenwood deck with aux input i'm running a kdc mp-728 and i run my pad through the aux in you just need a $5 rca to 35mm head phone jack if your taking about the factory deck that port on the back is a serial bus port for a factory cd changer that i don't belive mazda even made the option ...

custom carbon fiber wraped heat shield air intake, under glow, fog lights, audio syatem ( hot rodded one of my old amps can now handle a 1ohm load at 500w rms used to only do 150w max @4 ohm stable) led and neon lights through out the interior, custom 2" thunder bolt exhaust with removed resona...

they're not two speeds but two curicts one kicks in first if it's still hot it'll kick in the second fan aswell

or at least i think i wouldn't know any more i only have one that works and it's wired to a switch

Reaper
greg

you said you tunk in dynamatted but are the plastic pieces of the hatch dynamated if not pull them off and dynamat them also you can run a lenght of foam tape ( the thicker the better) along were the hatch meets the car you'll get a much better seal and you don't have to monkey around with the latch...

ok mike i took a look under the hood and in you little plug that goes to your fans there should be two wires one blue and one black the blue changes to a yellow wire and the black stays black (this is on the driver side fan ) the black should be your ground but on the passenger sid fan the colours a...

i've had a priet trip on ice in front of my car before and spilled his coffee on the hood could that count as being splashed with holy water

if so i think the demon is still in it

i'd say just stick with the 4-1 header on our cars you wont see much difference a bit but not much

welcome to my world i think mine is just from the ac pump but i will most likely be changing my steering pumpo as well