MX-3.com

I just got back. Was a sorry sight, hardly any cars compared to past shows and I didnt see one MX-3! I think I saw 2 Mazda 6's and maybe 2-3 RX-8's. Sad, just sad.

Anybody going for sure? I plan on going up on Saturday but I won't be entering either of the cars.

What was your compression across each cylinder before you started pouring oil down your spark plug holes? I apologize if I missed this. If your blowing smoke out the exhaust while pulling out of a dead stop this usually means the rings and cylinder walls are shot. If that is the case, not knowing ho...

I cleaned my up real good and used plastic epoxy on it. I just put it on all around the joint. Did it last spring, hasn't leaked yet, even when the car overheated because of a stuck thermostat 3 weeks ago.

Do a compression test and a coolant system pressure test. I'd guess a bad headgasket.

Good point, I think he's talking about the filler cap, its between the heads, the rap cap is on the right side of the rad. Sounds like he's got a good air lock.

I wouldn't recommend shaving your heads. I shaved my first set of heads .025-.030", not knowing how much slack I created the timing belt jumped a tooth. I had to resleeve the center idler pulley (between the heads) to take up the slack. I would recommend just cleaning up the surface and you sho...

The link comes from the PT 1st Gen's Forum. Are you sure they are the correct PN's for the KL Headbolts? I'm guessing they aren't.

9lbs is light enough. Stick with the Fidanza.

I'm interested in just one wheel if want to split the set up and sell them individually.

I have an extra GS Brake Booster/Master Cylinder. PM if your interested.

Check to make sure you have your 2 ground wires on the engine, I would go ahead and add a few extras.

Yes, but does that spoiler extend into the mouth area?

Yes that one, a CF version of that would be bad a--!

How about a CF copy of the JDM lip spoiler?