MX-3.com

On my wideband o2 , no matter what load below roughly 4k rpms the afr stays the same vs 4500+ both at part and WOT. Dosent matter if i go up a steep hill in 4th or second below 4k its the same afr, once over 4k though the afr drops. Alot of miata guys have problems running aftermarket turbo kits and...

Sounds like a bad o2 sensor/exhaust leak pre o2, our o2's control fueling below 4k rpms, after that the ecu takes over, hows the fuel economy?

where are you from?

SOLD

another issue with these cars is grounding. There should be a main ground for the fuel injectors by the thermostat housing, i know when mine was loose the car would act up like your describing, also over by the battery tray. Also check the ground at the fuel pump, take off the bottom seat cover, tak...

pending payment

spray the boot and the lines coming off the boot (valve cover and IACM). spray the fuel injector oring areas, throttle body and gasket area. Duct tape/electrical tape can be used for quick fix/diag. Your correct on your fuel pump idea, but you also must know inside of our VAF's there is a switch tha...

offers?
This goes on ebay tomorrow

sounds like a torn intake boot, start checking for cracks.

http://i12.photobucket.com/albums/a212/b6tpoweredmx3/334328273285-1.jpg Plans change, i no longer need a standalone for my goals, this ms was built by Lex on clubprotege. It has installed the big daddy map(4 bar) also has flat shift and launch control enabled, I have the main pigtail (not pictured)...

Parts guy at a local hyundai dealer. Basically in charge of parts,supplies,warranty returns etc etc. Aka glorified baby sitter. Its kinda funny when you try out some new brake clean and the first thing they do is see how flammable it is, they didnt like the new stuff it wasnt as flammable as the old...

yes more than likely it was me.

So tell me now If this ain't love then how do we get out? Because I don't know That's when she said I don't hate you boy I just want to save you while there's still something left to save That's when I told her I love you girl But I'm not the answer for the questions that you still have Rise Against...

I had a clunk in the right front too, make sure if youve done the ball joint that you used the mazda bolt that goes through the spindle, its a stepped bolt.

IIRC its 1/8" bspt

(british standard pipe thread)