MX-3.com

Timeslips???? I guess I am an idiot but ineed help with this one

I ordered my mazdaspeed mounts over a moth ago still have not seen them. So i called them 2 weeks ago and they said i will have them this past monday guess what no mounts. I called them again today and they said tey will recieve the tomorrow and i will get them next week. Anyways the told me they we...

installed my prm today and still waiting for my motor mounts from corksport-that is another story should i go with a fuel regulator or should i get a ze ecu i have a spare k8 ecu still running a k8 ecu with mx6 maf i do have a superchip installed but it was for the k8 i want to get the motor right b...

do get the motor mounts as i did not and now i wish i did you definetly NEED them take it from me its a lot easier to do when the motor is out

not a bad idea i think i want to change to a mushroom filters what type of kit would ineed to make it work

i have done the ze swap and when i went to install my intake back i noticed it was cracked open around where the ribs are and i need to know what intake i can but to replace the whole set-up from the filter to the tb i have a k&n filter but ineed the whole tunnel does the weapon r intake come wi...

what kind of wheel do you use and since i am planning a paint job should i just wait will the body shop charge more to remove them than to just paint it????

i have racing stripes on my car and they are starting to fade making it look like crap i am planning to get it painted but i just got done with the ze swap and iam concentrating on the motor bay right now i would liketo know if anyone has any bright ideas on removing the faded ones i have a hat gun ...

everyting is running fine but when i go for a test drive there is a loud vibration i dont think my buddy got the driver side axle all the way in i know it has a c-clip how do you get ut to seat properly any advice would help thx

i just got done with the ze swap and when i took my first ride i noticed that there was a loud vibration i need to know could it be the driver side axle is not seated all the way or what i know it has the c-clip and i feel that it is coming from that side is there a special way to install the driver...

i figured it out i just used my k8 disty i thoght that the k8 disty would throw it out of time shows you how much i know

i have found some answers but, i need to know when i pull the ze disty it looks like i will be out of time when i install the k8 disty i need some help

i just t00k a 1/4 in. pipe thread and tapped the neck on the klze you will see there is a flat place there and it plugs back up which is great

just got done installing the klze but i dont have any fire it turns over i used a distributor from a 2.5 mx6 same plug wires checked the crank position sensor i need help