MX-3.com

sweet, that's for the info fellows...

dang...ok thanks

All those warehouse on the net keep sending me a mount that don't even fit though it says fit Mx3 1.8L GS.. any ideas?


image sharing sites

Thanks,

I will definitely check it out.

I would like to buy a manual seatbelt conversion kit for a 1993 mazda mx3.

I am also looking for the center console for the said car.

I am located in the USA.

thanks

I will take them, do you have a paypal addy?

The cover on my sunroof switch broke so I need a new cover but I will buy the entire switch if you have it. I am also looking for the driver side door pin switch, I will take a pair if available.

Thanks

Well 350 km makes me feel better but 450-500?? I am getting around 220 miles/355 km so I think maybe I need a tuneup or our mx3 tank is not that big. I have a jspec 1.8l v6 with matching ecu and have a hard time starting at times. I can also smell raw fuel so i need to narrow it down. I have new plu...

How much you guys typically get out of a full tank of gas?

Thanks

do you still have the seatbelt assemble?

thanks fellows, I have a dremel but I will have to get the flex attachment. thanks for that pic Tunes67, will grab these sometime tomorrow but probably won't get to the car till next week. all suggestions is greatly appreciated, hopefully i will get it out as am moving in a month and would like to d...

thanks for the advice fellows, will give this a go in a few and let you all know how it turns out.

I would really hate to pull the engine again, it would be number three in a year, lol.

Well, my idea goes like this (have'nt tried it yet)

wear down a dremel cutting disc very small
try to use the dremel and put a slot in the broken screw
remove with flat head screw driver

easier said than done

Hello fellows, I was 108 miles from home when my mx3 just shutdown. i pull off the road and low and below my timing belt was off the cam staring at me. I then noticed that the idler/tensioner pulley was just dangling. The bolt that held it in place broke off clean and I don't exactly know the best w...

Well fellows, the meter fuse is fine and the line from the vacuum unit under the hood is connected to the manifold.

Is there anymore connections under the hood or can someone point me to a diagram of the crusie control system.

thanks