Search found 54 matches
- March 22nd, 2003, 8:25 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: Have question about auto tranni??
- Replies: 13
- Views: 195
Re: Have question about auto tranni??
Here's the complete sequence to get the transmission off: Disconnect the batteries and remove it there 4 10mm bolts that hold the plate under the batterie remove them, remove the airbox, air flow sensor and the tube that goes to the tb. there's two 14mm bolts that hold the starter to the transmissio...
- March 17th, 2003, 8:35 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: Performance Limitations?
- Replies: 5
- Views: 52
Re: Performance Limitations?
I won't to know why the escort ecu will not work with the gtx injector cause i'm currently running the gtx injector on that ecu.
- March 11th, 2003, 9:00 pm
- Forum: Forced Induction
- Topic: A few questions...
- Replies: 17
- Views: 669
Re: A few questions...
Hey guys the bov his ib between the turbo and tb it's there to releive pressure surge when you let go the gaz pedal. You plug the vaccum hose on the intake manifold after the tb so that when the tb close the vaccum augment and the bov open. It's there to prevent an overboost situation in the the int...
- March 10th, 2003, 8:09 pm
- Forum: Transmissions
- Topic: strongest auto tranny setup to fit sohc?
- Replies: 6
- Views: 833
Re: strongest auto tranny setup to fit sohc?
the lx was fwd has for the shaft there three size shaft in the mazda line. From experience the shaft of the precidia doesn't fit in the protege lx tranny tried it.
- March 9th, 2003, 11:04 pm
- Forum: V6 Technical/Performance
- Topic: SERIOUS ENGINE PROB! HELP!
- Replies: 12
- Views: 243
Re: SERIOUS ENGINE PROB! HELP!
check for vaccum leak high idle is normally a signal of vaccum leak.
- March 8th, 2003, 2:46 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: Engine Swap
- Replies: 3
- Views: 76
Re: Engine Swap
kia sephia here in canada has a bp. I saw one stupid guy with a sephia that had a sticker of a little guy pissing on mazda on his back window had to tell him that it had a mazda engine in there.
- March 4th, 2003, 9:19 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: protege motor swap?
- Replies: 10
- Views: 156
Re: protege motor swap?
front clip would be a good way of doing it simplify many thing in the swap. I would have gone on that road for my friend mx-3 if i had not had my old pro 1.8 dohc laying around. I just use the engine for the swap the rest his all his stock precidia rs 94 except for intake and exhaust manifold the re...
- February 27th, 2003, 9:28 pm
- Forum: Forced Induction
- Topic: Vris Mod under boost
- Replies: 16
- Views: 344
Re: Vris Mod under boost
If you could find me the fabricant i would apprexiate a lot thanks
- February 26th, 2003, 8:49 pm
- Forum: Forced Induction
- Topic: Vris Mod under boost
- Replies: 16
- Views: 344
Re: Vris Mod under boost
Where did you get those switches i'm searching for something similar and the only thing i found where pressure switches that i could not adjust
- February 25th, 2003, 10:32 pm
- Forum: Suspension/Brakes/Wheels/Tires
- Topic: kyb struts
- Replies: 8
- Views: 385
Re: kyb struts
My friend mx-3 also has that problem we changed everything in the suspension except the table bushing and there's still a clicking sound. His running the same set-up has my pro lx 93 and i don't have any problem for my part. We have apex coil with kyb gr-2 strut on our car. Can tell you that the mx-...
- February 25th, 2003, 10:15 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: how do i swap the BP26 ECU???
- Replies: 7
- Views: 84
Re: how do i swap the BP26 ECU???
I think Corksport has an upgrade for the computer to run the bpt but him not sure look in there site.<p>P.S. On va etre beaucoup de gtx cet ete moi aussi je suis entrain dans installer un dans mon pro lx et y'en a deux a quebec que je sais. Une couple dans mon coin a montreal.
- February 23rd, 2003, 10:41 am
- Forum: 4-Cyl. Technical/Performance
- Topic: Question about escort engine.
- Replies: 5
- Views: 61
Re: Question about escort engine.
It would fit but you would need the entire mechanic and electronic compare to the engine with exhaust and intake manifold only with the escort gt 91-96. Done this swap in a friend rs 94 and it's a piece of cake the only think his decide before if you want to go with the bp computer or stay with the ...
- February 17th, 2003, 8:57 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: Miata header
- Replies: 39
- Views: 201
Re: Miata header
The 4cyl 1.6l and the 4 cyl 1.8l do not have the same length so the exhaust hisn't a go fit.
- February 17th, 2003, 7:15 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: motor cut in hard rigth turns
- Replies: 2
- Views: 28
Re: motor cut in hard rigth turns
I'm starting to suspect the injector to has they are the original one of the 1.8l. I'm going to try the old 1.6 injector this weekend to see if it makes any difference. I don't think it the clutch has the engine fall in compression let me tell you that when your'e using the engine to pull you out of...
- February 16th, 2003, 6:00 pm
- Forum: 4-Cyl. Technical/Performance
- Topic: motor cut in hard rigth turns
- Replies: 2
- Views: 28
motor cut in hard rigth turns
Recently i have installed my old pro bp engine in a friend precidia rs. We went for a ride today and the motor cut on us in a hard rigth curve the trouble his that it was doing me the same trouble when the engine was in my pro.We just changed the engine so it's not a electrical problem has i tougth ...