MX-3.com

Would this work: http://www.quaifeamerica.com/qdf6f-0.html

Unless someone can tell me where a cheaper one is?

I won't be able to get it for a while, but I was wondering if anyone could help out, and I'm just putting this out here early so I might have time to try to reserve one or be picky-choosy. Thanks guys!

Just lookin at some work and wonderin when you can do my mx3 I can't wait to have to time and money to work on mine like this!

Would the shell of the 92 happen to be in good condition?

Well, I hate to say it, but I am officially going full lurker. I am moving to Idaho in a month and will be getting my bachelors in biochemistry. I will be unable to work on my money pit for the time being, however, I will have plenty of money once I get my career on the road (at least that's the pla...

So... I replaced the one line and now a line from the booster to the rear blew a hole in it. I was trying to follow it into the engine bay, but I'm not sure I had my car lifted high enough for the amount of twisting/searching required. Is there a trick to replacing these two lines without wanting to...

Could be a leak in the header with the egr appendage? If budget allows, replacing o2 sensor might not be a bad idea. Check over some of the hoses or electrical connections that may have been in the area of work. The easiest thing to troubleshoot I think would be making sure the intake piping doesn't...

15- Oxygen sensor or circuit 24- Rear 02 sensor inversion error However, the exhaust smell confuses me. Are you smelling it in the cabin? It would seem like the codes are being thrown because of an exhaust leak early in the system. Maybe an exhaust header gasket or something before the resonator. Th...

I drew a silver arrow with a paint pen on my tubes if I still get them wrong you guys can officially call me a wannabe mechanic

Well that makes things simple, that's the one I was looing at. What about the tubing that runs from booster to various caliper lines? Any place that sells that online?

Can anyone tell me where to get the ss brake lines that every one has on this forum? I can't find anything...

Is there a possible swap or replacement for the little module that is on the rear cross member? One of my lines has a hole in it so I'm replacing all the steal tubing and was wondering what some of you do about this.

Just as a type of census question if you don't mind answering, what did you have the most trouble with?

I am not sure I understand the issue... if you have slop on teh cable, is the accelerator cable actuator arm pulled taught enough to NOT be resting on the throttle stop screw? If your actuator arm is setting on the idle adjustment screw and you still have slop in the cable, then your accelerator ca...

Would a Mazda engineer or mechanic be able to get to the bottom of the horsepower debate that plagues k series engine forums?