MX-3.com

This is from a seller on the Facebook group "BG/Ford Escort Enthusiasts" and the general consensus was it was a b---- of a sketchy buy. The seller said they baked it after spraying it with the high temp paint and a lot of folks thought that wasn't good for the seals. Just an FYI folks, if ...

I think this is the longest running FS thread in the history of this forum. I will take the Installation Manual for USDM Side Skirts - I have been looking for these for YEARS. Pm sent! :mrgreen: Damnit, wish I had seen this. On the rare chance that Mark doesn't end up buying it I want it. Wish I kn...

Deadmaker is talking about Johnturboklze or something like that, think he may have been the first on the forum to do it. Mikeinaus did it too. http://i878.photobucket.com/albums/ab341/mikeinaus/IMAG0021.jpg http://i878.photobucket.com/albums/ab341/mikeinaus/IMAG0020.jpg Honestly, if you've got a wel...

bpt323 wrote:Last 2 i'll ever make.... open for reasonable offers. Pickup is welcomed on these also

I can't believe you still have these, every time a picture or mention shows up fifteen people will hound me about where I got them.

This is good quality s--- people, buy it!

Found this clutch set, can someone confirm that it will work with mx-3 k8? http://www.ebay.com/itm/251385311069?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 valeo part #52253603 Says right on the ad it should fit so I think you'd get a refund if it didn't. Lot of work for an annoying a-- ...

Your pistons and rods are weighted for a certain place on the crank. If you change it there will be a unbalance (not that good). This is a much bigger problem with v6s then other engines due to the vibration. About the piston location, it was explained to me that left and right are considered as if...

All MX3 springs will fit your MX3. THe springs for a GS are made for a slightly heavier front end but otherwise they will work and they will still lower your car. I have GS(1.8L) springs on my RS(1.6L) and it's fine.

I feel like this happens to me at almost every parts/paint shop i go to. The guys behind the counters treat me like a monkey when I give them specifically what I need. Just a month or so ago I wanted a universal oxygen sensor by bosch and I gave the dude the exact part number, the same one on their ...

+1 for Dan. When it comes to turboing, if you have to ask what you need, you're not ready for it. Lots of research should be in your future unless you're paying someone to do it all for you. You'll need: Turbo w/ wastegate(either internally or externally gated) Hot pipes(basically turbo manifold) In...

Sleeper6 wrote:they sent you the wrong bulb, send it back and get a replacement. Our civic has a HID kit with 9005 & 9006 with h11 for foglamps. They come in all different bases.

Bingo, I've installed a bunch of these in the last year, the bulbs should fit with no modification unless they're the wrong kit.

MazdaManiac is right, Erebuni front.

Wicked, how much you want for it?

Dash harness?

Any discernible difference in the feel of the car with the cage? Are you gonna lay down some carpet or anything for the rear or just leaving her bare? Even with the oil viscosity 8 seems low enough that it would worry me, might even be your oil pump(knock on wood, that's a shitty job to do in a car)...

8 PSI oil pressure eh? That doesn't sound so great…

Engine is looking top notch, hows the roll cage treating ya?