MX-3.com

Yeah, i turned the key around after i had jumped the F/P and GROUND

I tried to jump the F/P and GND but i could not hear any fuel pump sounds. But when i try to crank the engine the pump maked noise!

I tried to jump TEN and GROUND and turned ignition on, but there was no light at all at the CEL. Wonder why? Any has any link to a reader i can use to the mazda mx-3 v7 1997 model? Handheld or a USB connector to use with an computer? I have no ide what it can be now, i have decided to try to order a...

Okei, will go down an mesaure the end to end resistance in all of my 6 high-leads cables tonight. I tried to find out what these values shoudl be, all i coudl find that it should be 16kohm per 1meter cable, is this right? And i will try to find the diagnose box and try to find out if i have any faul...

I tried all the high-tension leads with a sparkplug in the end 5-10mm away from "ground" and the result was a small yellow spark. What can cause this fault? Is this the fault?

Tried that 2 times, but sadly no sucess:( Any other good tips of what i can do to find out of this? Can it really be bad compression in the engine?

What did Dan say? To disconnect the -pole on the battery and press the break pad down for 15 secounds?

I disconnected the hose from the fuel pump before it goes into the engine and than tryed to start the car, result was alot of fuel comming:) And it smells fuel when i remove the spark plugs and starts to spin the engine. The starter clicks rapidly, and the pistons goes up and down. I have now tried ...

1 day my mazda was running on idle outside my garage, i was about to check something so i removed 1 spark plug connector while the engine was running. Suddenly the engine stopped. I connected the connector to the spark plug again and than I tried to start the engine again, but it would not start!. I...