Search found 5 matches
- May 12th, 2010, 11:31 am
- Forum: V6 Technical/Performance
- Topic: K8 hesitation problem
- Replies: 8
- Views: 244
Re: K8 hesitation problem
If it is the temp sensor it should run ok when the engine is still cold, but go to crap when it gets warmer. The car does not use the signal from the coolant sensor until it is starting to warm up. Check your crank sensor by the coolant sensor too. If the wire gets frayed it will run klind of crapp...
- May 12th, 2010, 6:23 am
- Forum: V6 Technical/Performance
- Topic: K8 hesitation problem
- Replies: 8
- Views: 244
Re: K8 hesitation problem
car has new plugs, wires, fuel filter, cap, rotor, checked all those, those are good but i didnt check the temp sensor... u think that would make my car idle terrible and not have power?
- May 11th, 2010, 8:16 pm
- Forum: V6 Technical/Performance
- Topic: K8 hesitation problem
- Replies: 8
- Views: 244
Re: K8 hesitation problem
idle air control you mean?Muzzled wrote:try unplugging your iac...... like leave all the coolant lines in it but just disconnect the electrical part of it. see if that changes anything.
mine did similar things. tried this and noticed a drastic improvement.
- May 11th, 2010, 6:17 pm
- Forum: V6 Technical/Performance
- Topic: K8 hesitation problem
- Replies: 8
- Views: 244
K8 hesitation problem
Okay so I'm driving to my friends house and then all of a sudden my car was driving like s--- and started hesitating like it was going to die. So I pull off to the side cut the car off. Later that night i tried to drive it home (wasn't far) and it would bog down hesitate still and then pick up speed...
- May 10th, 2010, 11:30 am
- Forum: MX-3 Related Want to Buy Forum
- Topic: [WTB] V6 MAF sensor
- Replies: 1
- Views: 44
[WTB] V6 MAF sensor
As title states... need it ASAP...