MX-3.com

Ryan, Thanks for the tip. Unforunately the Escort ZX-2 Didn't make it to Aus. Is the Ford Probe suspension any good? There's a few of those about. Alternatively if any of the Mazda 323, 626, MX-5, MX-6 parts are compatible, that'd be awesome. What parts do I need to swap? Just the shocks or the whol...

Hey Guys, My rear suspension is really shocking, every bump shakes the whole car. It's been like that for ages, but I've finally decided I'd like to do something about it. I've got a pretty small budget, so I'd like to do it myself on the cheap. Any tips? In Aus, most of the Eunos 30x parts are hard...

Hey Guys,

I've put a nasty dent in my drivers side (passenger side for you yanks) front fenderwell panel and I want to replace it. It's apparently bolt on, but I don't have a clue how to replace it and couldn't find it in the online manuals. Can anyone provide any help?

JHZ

Well I'm feeling pretty stupid right now. The reason why the car wasn't starting is because I had the rotor on the wrong orientation. I got a new rotor with my new disty cap and it wasn't keyed like the old one so It could go on three different ways and I had it on the wrong one. :oops: After puttin...

Okay, looks like I have the Jap model that doesn't have a CEL, which explains why it wasn't lighting up. I put a LED between FEN and B+ and in Diag Mode (TEN and GND) it lights for 2 seconds and then turns off. Then I wait for codes to flash, nothing, still at least my PCM is okay. So there's no cod...

Okay, so I replaced the two fuses and so far nothings blown again, so not sure what was happening last night, but it's stopped. Maybe some of the wires around the dizzy were shorting and how they're not. Tried the car again, it seems like it wants to start (there's a rumbling from the engine, like s...

Okay so did the HEI mod (w/o coil) and it made it a bit better, but not much. Then I tried doing the external coil mod, so wired up the external coil and modded the dizzy. Ended up pulling the dizzy to pieces following the instructions on clubprotege looking for the tacho strap, but couldn't find it...

Bought a timing light and checked the timing, was okay. However found out that when I put my foot down hard, the spark stops. If I rev it up slowly, then the spark on cylinder 1,3,5 is okay at hight revs, but is gone from cylinder 2,4,6. I'm thinking its the distributor again. Might be worth doing t...

Did you manage to solve this mate? My K8 has exactly the same problem and it's driving me nuts.

Hmm, not a bad idea. I suppose I can try moving it back and forward a bit and see if things improve. It was running fine for a while after I changed it though, but maybe its slipped out of position.

Hey Guys, Got a bit of a pickler here. I have a 1995 Eunos 30X that's been running rough for a while now. After 2000 - 2500 revs it runs beautifully, but before that it's very jerky and has almost no torque so I have to rev the crap out of it before I can disengage the clutch to get it to move. I've...