MX-3.com

FUCKKKKKKKKKKK!!! nerd racing was right....should have spent the extra 7 dollars on the seal...i was driving back from school today and parked my car out on my drive way then later parked it in my garage to put my new amp in when i noticed a flipen wet spot on black top. I smelled it and sure enough...

What does ECO stand for and what would it do if or when it was wired correctly.

Baisicly ill run you threw how i did mine. It isnt pretty by ANY means but it does the job. Step One: Grinded down a section on the knuckle to allow stud to have space to go into hole. If you dont the stud will be angled and it wont slide in. http://i28.tinypic.com/2lduk3o.jpg Step Two: I Grinded do...

Allright spent about half the day workin on my car. finaly got it out of my garage. Thanks for the advice i used my mallet and started taking brutal swings at it and it finnaly decided to pop in. Stubern thing. I figured since i used my hands to pop it out i could use my hands to pop it back in, but...

yea thats basically what i did to get them out. I used my dremel and cut about 3/4 of it of and slamed it out with a sledge hammer and it comes right out. The problem is when you try to put a new stud in it wont fit in right so you have to grind it out a little.

yea i took my nuckle of my car and tryed to take the hub off and that thing didnt buge. I was tryin to change my wheel bearing and i was slamin a hammer into it from the other side and it didnt work. I also had to change my studs so i just decedid to grind down part of the nuckle and then grinded do...

Thanks for the advice. Im workin on it tomarro cuz i had work today. I know im definitly guna have to get that c clip on cuz if that shaft comes loose im going to loose the grease out of my transmission. ima just have to suck it up and whale on it with the mallet. Hopfully it wont ruin my shaft.

Allright if someone can help me get my car out of my garage it would be greatly apprecated...Im stuck at a dilema. About a week ago i pulled out my driver side axle(it craped out obviously). I pulled out the axle from the transmission easly just forced it out with my hands, then cut of the bolt on t...

OMG i was about to post to ask how to do this cuz im havin the same problem. Wher did you end up having to put it? I got a 92 4cyl and i cant find the danm speedo cable. Theirs no level plug on the side of the trans and im pretty sure i got a f series tranny cuz i got the cheapass model. Any help? t...