Search found 153 matches

by lazzer408
September 4th, 2008, 1:19 am
Forum: Electrical & Lighting
Topic: Electric, or deeper?
Replies: 14
Views: 691

Re: Electric, or deeper?

Image

Image
by lazzer408
September 4th, 2008, 1:14 am
Forum: Electrical & Lighting
Topic: Electric, or deeper?
Replies: 14
Views: 691

Re: Electric, or deeper?

Getting the codes was one of onlytrueromeo steps. 3) Take a paperclip and put it in the diagnostics box on the right hand side of the car (WITH THE CAR OFF) - jumping the pins GND and TEN. Use the search button here for a more detailed explaination, or check out the FAQ section. Just be careful when...
by lazzer408
September 3rd, 2008, 12:43 pm
Forum: Electrical & Lighting
Topic: Electric, or deeper?
Replies: 14
Views: 691

Re: Electric, or deeper?

I'm thinking maf because of his start up issue. Almost as if the ecu has to fail it before going into limp mode.

ARE-THERE-ANY-CODES ???
by lazzer408
September 3rd, 2008, 1:17 am
Forum: Electrical & Lighting
Topic: Electric, or deeper?
Replies: 14
Views: 691

Re: Electric, or deeper?

I've -never- seen an air filter plugged to the point of poor idle even on carb'd engines. A fuel filter plugged would run worse as engine load increased and fuel demand was higher. This is an idle issue from what I understand.
by lazzer408
September 2nd, 2008, 7:49 pm
Forum: Mid-West USA MX-3 Club
Topic: Lake Villa IL?
Replies: 17
Views: 8878

Re: Lake Villa IL?

Who what where when? A new shop? That does Mazda? sweeeeet. Who is it?
by lazzer408
September 2nd, 2008, 2:55 pm
Forum: V6 Technical/Performance
Topic: Resurfacing a fidanza
Replies: 16
Views: 416

Re: Resurfacing a fidanza

WhiteFinish wrote:Is it just unscrewing bolts and putting a new plate on there ?
Yup.
by lazzer408
September 2nd, 2008, 2:53 pm
Forum: MX-3 Related Items For Sale/Trade
Topic: [FS] GS part out. CARS GONE
Replies: 7
Views: 505

Re: [FS] GS part out.

What year is it? How much for the... -spoiler -plastic dash panel/console with or without buttons/switches (needed for painting) -interior trunk cover if not broken -rear speaker covers if not broken -maybe the seats (what color?) I'll get back to you on those rear brakes we talked about. I'm gather...
by lazzer408
September 2nd, 2008, 2:46 pm
Forum: MX-3 Related Items For Sale/Trade
Topic: [FS]misc. parts
Replies: 2
Views: 298

Re: [FS]misc. parts

Is the BP rail stock?
by lazzer408
September 2nd, 2008, 2:45 pm
Forum: Forced Induction
Topic: Turbo
Replies: 10
Views: 1365

Re: Turbo

Depends on your compression ratio, ignition timing, effectiveness of the intercooler, a/f ratio, and everything else that can attribute to detonation. Octain being one of them. Assuming your engine is stock otherwise, yes you'll need to run premium. You might get away with midgrade if your boost lev...
by lazzer408
September 2nd, 2008, 1:27 pm
Forum: 4-Cyl. Technical/Performance
Topic: Escort GT and Protege distributor WILL work in an MX3 RS
Replies: 16
Views: 1753

Re: Escort GT and Protege distributor WILL work in an MX3 RS

The - STOCK - distributor has the CAS, Ignitor, and Coil all built into the distributor itself. That distributor is a pos. This thread explains how to convert that all-in-one setup over to the common (cheaper) EscortGT/Protege ignition system. It works with the B6 ECU. I'm planing on boosting my BP ...
by lazzer408
September 2nd, 2008, 2:41 am
Forum: Electrical & Lighting
Topic: Electric, or deeper?
Replies: 14
Views: 691

Re: Electric, or deeper?

so it doesnt idle? Check iac. also check airflow meter. CEL? Any codes?
by lazzer408
September 2nd, 2008, 2:36 am
Forum: V6 Technical/Performance
Topic: Quick timing question
Replies: 6
Views: 182

Re: Quick timing question

Image
by lazzer408
September 2nd, 2008, 2:32 am
Forum: MX-3 Related Items For Sale/Trade
Topic: [FS] B6 turbo, Complete engine/trans $400.
Replies: 10
Views: 467

Re: B6 turbo complete engine/trans $400.

I've ran the vj-11 and it's fine. The vj14 was cheap and I'd rather have the ubber spool. Good 11s go for ~100-150 and the manis go for ~50.

I have another matching vj-11 and still considering boosting the g/fs 3.8 stang. :D

Need the mani? It was welded where they all crack. $50
by lazzer408
September 1st, 2008, 11:05 pm
Forum: 4-Cyl. Technical/Performance
Topic: Escort GT and Protege distributor WILL work in an MX3 RS
Replies: 16
Views: 1753

Re: Escort GT and Protege distributor WILL work in an MX3 RS

Looks like this. It is mounted below the ignition coil on the same bracket. Drivers side inner fender on Escort GT and Protege.

Image
Image
Image

Go to advanced search