MX-3.com

I was troubleshooting my EGR system and the nipple for the tube going from the vent solenoid to the EGR valve was broken. I super glued it back on and reinforsed it with epoxy. worked great, the check engine light stopped coming on. However, I moved to california where they do extensive checks on th...

The plastic end on the vent vacuume solenoid broke off and I cant find another one through any of the auto part stores. Anyone know where I can get one?

the emergency brake only applies to the rear brakes and have no affect on the front brakes - so i dont see what good having the emergency brake on would do when trying to remove the front axle nuts - the only way to remove the axle nut is with an impact wrench - as was stated. 33mm socket, breaker ...

I perform on weekends, and don't know what day yet, but I'm down! I know of a fun drive along the gorge near Vancouver. We could start or end @ CorkSport.. It's near the drive. I would like to meet the Seattle-ites. LOL, The gorge on the washington side? where the stonehenge thingy is? LOL I got a ...

tell 'em napa list's the same part for 49.95 and they'll match it.

All napa computers keep coming up with the wrong part for the flywheel but kragen/shuck's/checker, as much as i hate to use them carry the same flywheel manufacturer, "Standard Flywheel" part SDF 918. http://www.partsamerica.com/ProductDetail.aspx?MfrCode=SFW&MfrPartNumber=918" on...

Yes, MU11211. That's the one I got.

ok brake light fixed. low brake fluid. go figure the seat belts are just wierd though. if theyre locked I can unlock,lock,unlock etc. and it works right away each time, but if i keep doing it it will stop at some point and take thirty seconds or so to relock. i remember a few times where it didnt lo...

Ok, Somehow the "meter" fuse under the dash blew when I put the battery in and it blew to where even when i pulled all the fuses and looked at them they looked fine but when i checked them all for continuity that one was bad. LOL

I checked all the fuses under the hood for continuity but only visually checked all the cab fuses even pulled em out to check em. but when I studied all the electrical schematics I saw that all the problem circuits that were in question went through the "meter" fuse under the dash so i pul...

I cant log on to the online manuals. I use this username and password but it says I'm not in the data base. What do I need to do to access these?

The battery has a full charge, I replugged all the connections, I even have voltage at the circuits in question at the dash fuse panel. It runs and drives perfectly. headlights work. hazards work. I did lower the engine quite a bit to get the tranny in and out but paid close attention to the wires w...

I just checked them all with an ohm meter and they're fine. They also have a visual indicator window but I double checked with the meter and they're all good. just noticed the temp doesn't register either.

After installing everything and buttening it all up i noticed a few problems... Please note that three electrical connections from the transaxle are hooked up as before. 1st problem: Automatic seat belt went foreward when i opened the door but did not return when i closed it, tried the passenger sid...

Im sort of angry with napa for the problems i had...... same one's available at Kragen/Checker... its an STD 918, Napa or checker should both be able to get it. The Clutch comes from Perfection Clutch part number MU1121-1, hope this helps....