MX-3.com

You can get a waterpump/Timing belt kit off ebay for cheap. There good kits. Lots of people have used them. Including myself. You can also find a gakset set for cheap there also.

MazdaManiacMx3 wrote:I like hot women in hot cars..
Both of them are a lot of work..

B.I.N.G.O

Intake manifold, valve covers, CAI might be. But thats about it. She is in need of some de-greaser. That and my rad suport is in need of some paint. I wish I would have got a c/f one when they were around.

Its like window visors for your vents. Keeps the rain out.

I think he means the Window ones.

Good luck. Check ebay.

Should do all the belts sence the motor is out. Intake gaskets, Valve cover gaskets. (Put Gasket Lub / Oring Lube On all gaskets) Clean the intake up sence you already have it off. Pull the oil pan and clean the junk out. sludge and such. New silicon for the pan. water pump, timing belt kit. check t...

My Dirty Bay

Are you sure you lined up the marks after retiming. Are you getting spark,gas. No vac leaks anywhere?

anything with 4x100 bolt pattern. Most Imports run 4X100's.

Get low expansion Hi-density foam. Spray in a layer and let it dry, Do this a couple times so that there is next to no air pockets. Then I used a hacksaw blade to cut the foam to the disired shape. You can also use a sander. Next I used fiber-glass and resin and put on two layers. Next I put on some...

I removed my wiper a couple years ago. One nut on the back. If you need to replace the hole unit you have to remove the trim under the hatch. IIRC there is three screws holding a cover over the motor. Disconect the harness, Couple bolts holding it to the hatch. Remove the one nut on the arm from the...

I just pulled one from a yard for $20. I got a kl02 vaf, kl01 ecu for $40

Get a pulley puller.

They should be the same. I ran the both on my car. No issues.

Mooneggs wrote: I like that crazy spoiler! sweet!

That thing is BIG! Is that a OEM part?? or aftermarket?

BUMP!!!