MX-3.com

Hello everybody im from British Columbia and this is my 1994 RS MX-3

Got this car already done with alot done to it, lowered, body kit, stereo and alarm with new 18'' with new tires

also has some mechanical problems, valve cover has a leak, some body rust repairs need to be done, and fiberglass needs to fixed in some areas. got it for just over $2,000.00

The engine is a 1.6L DOHC 4 cylinder also its A 5 speed

Parts installed after i bought the car:
Tokico struts
new rotors
new calipers
new hubs
Kicker 6.5 speakers

Parts soon to be installed:
Magnaflow muffler and tip
2 12inch Alpine Type-s Subwoofers
1500 watt Hifonics zeus amp

Sharp car! Its nice to finally see someone with an MS bumper and foglights, looks goofy with the empty holes. Looks like you've got the whole MX3 MS A-Spec kit, love how clean it is white.

Whereabouts in BC are you? Looks like you're from the coast if those pictures are recent, I'm from over in the Radium, BC area originally and there aren;t too many clean MX3s there.

I live in coquitlam BC and thanks

AAHHHHHHHH I LOVE IT!!!!!!!!!!!!!!

Trade wings with rob up there and your car is perfect!!!

Welcome man!!

Your car is gorgeous!

Hey Coltan you finally ventured over to this forum now.... It Adam... Did you and Rob get that knuckle installed yet?

The knuckle off your car was fine, you did a good job installing it I haven't had any problems...

Hey Adam we havent got the knuckle on yet but it will be installed very soon

Very nice car and welcome! Hope one day my car will come close to looking like yours in some ways.

Thanks

Hey, welcome to the forum!
Some reason, I can't see the pics.

Well at the rate we have meets over on this side of North America, I'm sure you'll come down with Rob and Adam!

Welcome to the forum !
Like Kulluminati777 said all you need is the MS wing your car is complete !
A-Spec

installed my subs

Sooooooo I havent updated this in a while so here we go :P

After installing my soundsystem me and my uncle headed to the engine bay where i had an oil leak



we took off many parts like the timing belt, waterpump, valvecover



Then we replaced them all with new ones and painted the valvecover :)





Then I bought a pair of Corksport strutbar for the front/rear and bought new sparkplug wires

(engine bay as it sits right now)


Soon to come i will be installing a twm preformace shortshifter with corksport bushings and hopefully a cold air intake



Some pics of my car at the revscene summer meet and at autocross where i watched my uncle race in his awesome 323





My favorite pic of my car right now :)

Since this is just a introduction thread you should start a thread in the worklog section. I wouldnt mind seeing the progress you make on this beauty