Page 1 of 1
[WTB] KL Starter, 36-1 pulley
Posted: January 27th, 2013, 8:19 pm
by Ryan
36-1 crank pulley
MTX K8/KL starter
I may add some other stuff as I think of it. Prefer one seller. Shipping to R0A 0V0 Manitoba Canada
Ryan
Re: [WTB] KL ECU, front pads, etc
Posted: January 27th, 2013, 10:15 pm
by MrMazda92
I have a KL47 ECU sitting on a shelf... I want to say Millenia ECU, right?
If you'd be okay with the VRIS points being off, shouldn't be too bad.
Re: [WTB] KL ECU, front pads, etc
Posted: January 28th, 2013, 12:58 am
by 2fazed
I have either a Kl55 or Kl57 if interested.
Re: [WTB] KL ECU, front pads, etc
Posted: January 28th, 2013, 1:06 am
by Ryan
Either of you have spare front pads, or LBJ's?
Re: [WTB] KL ECU, front pads, etc
Posted: January 28th, 2013, 10:49 pm
by MrMazda92
I have 2 lower ball joints, but one has a boot that is toast... The other has maybe 5,000 miles of travel on it, and has a grease fitting attached.
I'm only getting rid of it because I need to swap to the 94+ 18mm shank style ball joints for my current project.
I do not have extra pads at the moment, unfortunately.
Re: [WTB] KL ECU, front pads, etc
Posted: January 29th, 2013, 4:07 pm
by 2fazed
I might, but I don't know if their gs or rs pads
Re: [WTB] KL ECU, front pads, etc
Posted: January 29th, 2013, 5:48 pm
by Ryan
doesn't matter IIRC, fronts are the same.
Re: [WTB] KL ECU, front pads, etc
Posted: February 17th, 2013, 10:53 pm
by Ryan
Bump, added starter.
Re: [WTB] KL ECU, front pads, etc
Posted: February 18th, 2013, 2:07 am
by crazycanadian
I have a KL01 ecu.. and KL88((I think- its stock mx3 1.8 V6).. also have the matching JE50 VAF...