MX-3.com

I am overengineering an IM, and am looking at roller barrel design, since it would actually be the easiest. However, it doesn't seem streetable. I would also like to try to make a pinch valve.
I say overengineering, but it will be very simple, when finished. I would love opinions, and 3D CAD flow charts
I would also like 40mm camera shutters.

If you utilized a LONG hood scoop, you could aim them forward and do individual cone filters w/ velocity stacks, and make the runners identical lengths(aimed towards the front of the car) you could make an ITB setup with major low end torque potential.