MX-3.com

Who can tell me what size I need for the reservoir and the master brake cilinder ?

The reservoir doesn't fit in combination with a longneck. I want to make a small line / plug to mount the reservoir a bit to the right.

Here it says M10x1, but isn't that the connecting lines ?

http://www.raybestos.com/wps/portal/gen ... dName=BDBL

Thats the size/thread pitch going into the master cyl. I would honestly stick with the 15/16ths stock master cyl. It does provide enough volume of fluid to properly work with the Mx brake system. It's the calipers, pads, and rotor size that will give you an upgrade in braking torque. You can check out the thread I started a couple yrs back on my brake setup.