MX-3.com

hey guys

im in the middle of pulling my ze out of my winter car. got everything done, wires, exhaust etc. i got side and front mounts off, and the one in back instead of taking the bolt and nut thats in it going this way ------- i took the 2 nuts off the bottom under the skid plate for the tranny. so the whole engine mount comes out. but when im pulling the engine up its pulling the passenger side up and the drivers side isnt coming up with it, and when it does its bring the tranny with it, im not taking the tranny out just the engine, an i got all the bolts that hold the tranny and engine together.. what else could be stopping the engine from coming out? its already apart from the engine/tranny

manual or auto..

spline still connected (axle ) possibly

clutch line

clutch

not many things there holding it

take a picture for us

^agreed

It seems you've done this before, but you have to separate the engine and tranny horizontally before moving one or the other vertically.

Day old thread so hoping you've got it sorted already.

The input shaft of the transmission is still engaging your flywheel. youll need to drop the lower crossmember for the transmission and are best of removing the tranny from the bottom then the engine out the top for the quickest removal install.

Second the input shaft.
Also, check the passenger side's intermediate shaft (jack-shaft, some have called it), may still be bolted to engine (?)

hey guys ya i just said screw it and i put 2 bolts back in the bell housing, removed the shifter, skid plate under the tranny, removed all engine mounts wires, power steering hose etc. and she came right out. all done. now its rebuld time. I will make 2 work logs, one for my summer car what ive done, and now this one..