Ryan wrote:This number changes dynamically according to (basically) RPM versus Throttle position or MAP.
It also depends on a few other details.
You won't find a VE table unless someone somewhere has written a tune for a B6 with your EXACT setup.
Any cheap tunes are called Alpha-n, which is RPM versus TPS.
This tune is written for a SPECIFIC engine. even between motors, it won't be the same. The tune has exactly zero capability to change according to hardware changes (intake leak, exhaust leak, burnt valve, low compression, CAI, exhaust changes, etc)
You can crunch the numbers yourself though.
The manual will spec a manifold vacuum at idle. Using that number (the pressure inside the plenum) you can figure out how much air is filling the cylinders, and start there. You could assume atmospheric at wide open throttle and low RPM, and assume close to 100% VE. (assuming lower VE will net a more rich tune, which is safer than lean)
VE will trend upward with TPS and downward with RPM.
I was definitely under the assumption of the VE to specific engines, more looking along the lines of a general idea of VE for the B6. I was thinking somewhere in the neighborhood for 80%-90%, which isn't too bad for a 16 valve, though SOHC, at 5000-6000 RPM at WOT. Then again, there are so many variations, as you stated, given atmospheric pressure, sensor output, and a slew of other variables that can't really be accounted for unless I bring the car to a shop and have them plug in a barrage of sensors.
Mainly, I'm wanting the VE to design an intake around that particular number to net the most amount of horsepower and torque at mid- to high RPM. Of course, I'm no engineer and am not that great with the math, but since there are quite a few calculators out there and some good tutorials, I think I might be able to get the hang of it.
A bit off the subject, but I'm leaning towards (and I know, designing an intake is a little pointless since there are some available out there and they don't give that much of an increase in horsepower, maybe 1-3 depending on RPM, but it's just the matter of designing one specific for this engine, and heck, someone may want to know in the future) 2.5" near the throttle body and enlarging to 3", with either various couplers or tapering by fabrication and welding, close to the MAF/air filter.
Reasoning for the larger pipe at the beginning and tapering to a smaller diameter is this; the 3" pipe would be excellent for upper RPM, where some of the power is lacking, however, at lower RPMs, where you'd need the get-up-and-go there wouldn't be enough velocity. With a 2.5" pipe, or smaller in general terms, would be great for low RPMs, but lack the volume for 5000+ RPM, essentially choking the engine. Yes, a lot of velocity, but not enough volume. Of course, air cannot be compressed without some sort of forced induction; turbocharger or supercharger, which would greatly increase the amount and velocity of the air going to the engine. And, since I'm no scientist either (nuts), I'm also assuming that with a larger pipe at the beginning, and tapering down, it would potentially increase the amount of volume initially, at least to a point, and then increase the velocity the closer it got to the reducer. Fluid dynamics is not a strong suit of mine, but I'm thinking that with the reduction in pipe size will act such as a funnel; increasing the velocity the smaller the pipe, hence why I want to know the rough estimate for the VE of the engine, to design the pipe size.
But I could be wrong.