Wiring a 110A alternator in, on KL, w/ no harness.
Posted: June 17th, 2011, 9:08 pm
I'm putting in a 110A Millenia alternator, and have read through the instructions here: http://home.comcast.net/~elves1/tunes.html
In this case, "the Red wire is the L or Lamp wire.. The Green wire is the IG or Switched +12v wire and the Black wire is the Signal wire."
I don't think the ECU addresses electrical load as that is what the regulator is for.
Here is the charging system diagram for a "93 626. I forgot to find the one for the Millenia alt with the three-wire plug.
http://i153.photobucket.com/albums/s...gsystem626.gif
Can someone specify where L, S and IG are meant to go?
Also, I don't have the stock warning light. Can I just wire in a light and tape it to the dash if need be? (Ugly, not permanent, but I just need to make it work.)
In this case, "the Red wire is the L or Lamp wire.. The Green wire is the IG or Switched +12v wire and the Black wire is the Signal wire."
I don't think the ECU addresses electrical load as that is what the regulator is for.
Here is the charging system diagram for a "93 626. I forgot to find the one for the Millenia alt with the three-wire plug.
http://i153.photobucket.com/albums/s...gsystem626.gif
Can someone specify where L, S and IG are meant to go?
Also, I don't have the stock warning light. Can I just wire in a light and tape it to the dash if need be? (Ugly, not permanent, but I just need to make it work.)