Page 1 of 1
Hatch Cover
Posted: March 30th, 2011, 8:10 pm
by anjin1982
So after months of putting it off i finally started to start my project of giving myself i hatch cover (since my last broke to a point in which it looked better off than on) and after test fitting the 1/4 inch birch i noticed theres to ropes hanging from underneath the soon to be cover...whats it for? i know the top ones attach to the hatch to lift with the glass but the bottoms ones?...
Re: Hatch Cover
Posted: March 31st, 2011, 1:36 pm
by Dragon1212
anjin1982 wrote:So after months of putting it off i finally started to start my project of giving myself i hatch cover (since my last broke to a point in which it looked better off than on) and after test fitting the 1/4 inch birch i noticed theres to ropes hanging from underneath the soon to be cover...whats it for? i know the top ones attach to the hatch to lift with the glass but the bottoms ones?...
Theres clips inside the trunk area so that it stays down supposedly. They are on the side of the panels just forward of the strut towers.
I'd post a pic if i had one.
Re: Hatch Cover
Posted: March 31st, 2011, 7:47 pm
by Dragon1212
Here you go
Look below his bar, on the plastic panel that clip thats where they go.. i've never used them
Re: Hatch Cover
Posted: April 1st, 2011, 7:34 pm
by Hoodzy
Probably to stop it from rattling?
Re: Hatch Cover
Posted: April 2nd, 2011, 2:36 pm
by anjin1982
Yea i remember now thanx Dragon1212..