[WTB] Spoiler, Harmonic Balancer, Interior

[Jeremiah73]

I recently purchased my second MX-3, 1993, it had an oil leak in the crankshaft seal which destroyed the harmonic balancer, so that needs to be replaced before it completely fails.

The spoiler was stolen prior to me purchasing the car, so I need to have that part.

The interior is torn to shreds, so I need to replace most of that.

If you have any of these parts, let me know.

[SteeleMX3]

I've got the sweet seats prior to 94, the one piece ones, in pretty much mint condition. Where are you located, I don't think it'd be worth yours or my time to ship these but if you want em...

edit: I've also got the multi-coloured door panels (all 4)

[Ryan]

we need to know your location. Thanks for posting in the correct format!

[Sleeper6]

As for the harmonic balancer what size engine do you have?

[mx3sohc]

I have an almost complete interior, black. Including both peices of the rear seat, non ripped. in good condition. $150 + Shipping for the whole interior minus the front seats and door panels. If you want door panels add $40.

[Evo_Spec]

aren't every harmonic balancer's made specifically for their matched engines? i don't think you should get one from a different car/engine, you should find a company that can balance it for your engine (but i'm not sure if i'm even correct)

[turpro1993]

I have a spoiler for you. If you're in the us I'll do 70 shipped

[Ryan]

Evo, I wouldn't say that;s correct, for these. But this is just how I see it.

I think every was mass produced within tolerances that would make any combination a good one. Rods, cranks, pistons, harmonic balancers, flywheels.

These are Japanese mass produced cars , not Alpha Romeos.

[Sleeper6]

Evo, I wouldn't say that;s correct, for these. But this is just how I see it.

I think every was mass produced within tolerances that would make any combination a good one. Rods, cranks, pistons, harmonic balancers, flywheels.

These are Japanese mass produced cars , not Alpha Romeos.

Any time you take an underdrive pulley you should match it too a lighter flywheel or you can cause premature wear.. but yeah it would be minimal on these. Oh keep in mind you can get a replacement through the dealer and theyll send you the new design one peice unit (no more rubber wearing out) and honestly its not much heavier then the underdrive pulleys anyhow. I had to get one last summer and it ran me about $250 since the Unorthodox one had a sleeve that hit my timing pulley

[bigdaddyj666]

i have a teal gs spoiler if your interested i live in arizona let me know.

[cout]

I see some people have already replied here, but in case you are still looking for some of these parts, I have available:

• Quite a few of the interior panels (in grey)
• Two door panels
• Yet another spoiler (in primer grey)