Page 1 of 1
Eunos 800 ECU?
Posted: December 13th, 2009, 3:18 pm
by unclegreg
What ECU does the Eunos 800 with Curved Neck use originally?
KL31 and 36 is right for the straight neck but with the Curved you have to chip or run with different VRIS points on 31/36.
Could be interesting to know
Re: Eunos 800 ECU?
Posted: December 13th, 2009, 3:20 pm
by solo_ryder
It uses some 4 plug ECU IIRC that is not entirely compatible with the mx3. Its more like a OBDII looking ecu. I think its like a KL68?
Re: Eunos 800 ECU?
Posted: December 13th, 2009, 3:40 pm
by unclegreg
Ok, is it the same for Millenia/Xedos 9?
Re: Eunos 800 ECU?
Posted: December 13th, 2009, 4:36 pm
by solo_ryder
I think so yes. The only compatible JDM ecu is the kl31/36 otherwise you get your k801 chipped
Re: Eunos 800 ECU?
Posted: December 29th, 2009, 8:57 am
by Nd4SpdSe
Been discussed many times. The Eunos 800/Millenia uses an OBDII system along with a MAF sensor instead of our VAF. There was rumors here and there about Probe/Mx-6 owners doing a conversion over, and it's possibly possible, but it's not the PnP solution that you are looking for.