MX-3.com

I re-wired my disty to work, but now I just need a KL07 ECU I believe. I need it for my 1993/94 Probe GT 2.5L V6 engine, Manual Transmission.

I thought I might be able to use a K8, but that won't work unless I spend money on the chip. Please PM me if you have one. I have cash ready in paypal.

Thanks for your help.

I have a extra one, but unfortunately I am keeping it. I don't wanna get stranded on the highway lol.

However, any disty should work IIRC. If you are getting a ZE, then the disty on there will proly be a 7 nipple disty or some kind of weird KF one, that may or may not work.

It's a KLDE from a PGT (93) that is already swapped in. I'm trying to get this one to work but I have to figure out the wiring for it since the input and harness are wired differently (since I had the "specific" 94 disty. Thanks though.

Still interested in buying one of these.... anyone?

T0T57171 is the exact # disty I need......

Please??????

You can also use a kf34 tot57271 disty off a 95+ mx. I know cause a tot57171 works on obd2 cars

does that use a cam sensor? Also, do you happen to know if the 3-pin harness is wired the same as the 94 disty?

mazdags94 wrote:does that use a cam sensor? Also, do you happen to know if the 3-pin harness is wired the same as the 94 disty?

I am not sure, all I know is that we put a 94 disty in a 96 car and it works fine so I am guessing visa-versa should work. I would think that the cam sensor is in the disty yes.

As for your 2nd Q. I am not sure what you mean, are you talking about the small plug on the 94 disty? I guess if it was wired differently on the 96 it wouldnt work with the 94 disty but it did. The distys look identical

I have a disty off a 93 works great less than 5k miles on it. As far as I know it will work. I think obd2 cars the 3 pin harness wires are different. Anyways I can get a part number off it?

Sure, also, if you could check to see what the color order is of the 3-pin harness I would appreciate it too. Let me know what it would be shipped to 14075. Thanks.

Bump, also need a KL02 or KL07 ECU. Thanks.

Hey I happen to have a kl07 aswell... pm sent

i have a 95+ disty that i can sell u

I never understood why the different distys don't always work, I mean, it's the same engine isn't it? Can someone explain?

they work like for example if u have a obd1 mx3 and try to use a obd2 disty u need to move the 3 pin wires from the harness that connect to the disty(3 pin plug).