Page 1 of 1
ecu
Posted: July 15th, 2009, 3:12 am
by mccabe
ok so if i get a mx6 v6 ecu and kl02 vaf can i run it on my mx3 de
Re: ecu
Posted: July 15th, 2009, 6:25 am
by mazdags94
KL02 or KL03 ECU with KL02 VAF combo should work just fine. It'll make the engine still think it's in an mx6. If you have two coolan temp sensors, your fans will just stay on all the time unless you wire in the extra sensor.
I'm actually going to be running that very setup on my mx3 except the engine (DE) is from a 93 Probe GT.
There are a few posts on here regarding the ECU VAF combos.
Re: ecu
Posted: July 15th, 2009, 7:46 am
by Nd4SpdSe
Your motor is a DE
The Mx-6 uses a DE
The Mx-6 ECU and VAF are for a DE
Should be obvious enough.
Re: ecu
Posted: July 15th, 2009, 11:38 am
by mccabe
ok so i was looking thro the latest post and i found that you could use a k8 ecua and kl02 vaf and it would work has anyone tried this
Re: ecu
Posted: July 15th, 2009, 3:06 pm
by Dan [Sac]
Ayeee, wrong post.
Re: ecu
Posted: July 15th, 2009, 4:01 pm
by Nd4SpdSe
mccabe wrote:ok so i was looking thro the latest post and i found that you could use a k8 ecua and kl02 vaf and it would work has anyone tried this
Many; that's why we say you can do it. It's not ideal, but it works.